Loading ...
Loading ...
Loading ...
QUICK START GUIDE
u-line.com
10
QUICK START GUIDE
u-line.com
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
Integrated Panel Installation
1. Fully open door.
2. Starting at corner, pull
gasket away from door.
3. Continue to pull gasket
free from gasket channel.
4. Upon removal, lay gasket
down on a flat surface.
5. Partially loosen the 3 screws, securing the top hinge to
the cabinet.
6. Align the panel with the outside edge (opposite the
hinge) and high enough to align with the highest point
in the door.
7. Insert panel underneath top hinge and apply upward
pressure while bringing the lower portion of the panel
flush to the door inside the lower hinge. The panel will
fit snuggly.
8. Align door with cabinet. Tighten the top 3 screws,
securing the top hinge to the cabinet.
NOTICE
Due to differences in floor construction or
surrounding cabinetry, the panel may not
sit flush with the top of the door.
9. Secure integrated
panel to door using
clamps. A robust
tape may also be
used. U-Line
recommends the use
of bar clamps to
secure the panel to
the door. If using
tape, be certain the
tape will not damage
panel finish upon
removal.
10.Using a 7/64" (3 mm)
NOTICE
It is important to ensure that all drilled holes are
drilled to the correct depth in order to avoid
splits in the wood when hardwood is installed.
11.Locate 6 of the #6x 1-1/4" (32 mm) screws provided
with your unit.
Align Panel
Against
Door
Edge First
Align Top Of Panel With Highest Point Of Door
Door
Panel
Wood
Panel
Door
Bar
Clamp
Bar
Clamp
(Amended)
12.Using a Phillips screwdriver, place one screw into each
of the 6 pilot holes and screw down. Do not overtighten
screws.
13.Be sure the screws force their way past the opening on
the gasket channel and sit flush against the bottom of
the channel.
14.Remove clamps from door.
Integrated Panel
Integrated Panel
NOTICE
If panel requires additional adjustment after
removing clamps, slightly loosen each screw and
adjust panel as necessary. Tighten screws upon
completion.
15.Starting at the corners, re-install the gasket into the
gasket channel in the frame. Make sure the gasket is
fully seated. This may take some force.
drill bit, drill 6 pilot holes into the wood
panel 1/2" (12 mm) deep using the
holes in the door frame as a guide.
Loading ...
Loading ...
Loading ...