Loading ...
Loading ...
Loading ...
TROUBLESHOOTING CHART
PROBLEM
Loss of power
Poor cut- uneven
Excessive
vibration
Starter rope hard
ito pull
Grass catcher
not filling (ff so
equipped)
_topu_
CAUSE
• Rear oflawn mower housing
or cuttingblade dragging
inheavy grass.
• Cuttingtoo much grass.
• Dirtyair filter.
• Buildupofgrass, leaves,
and trash under mower.
• Toomuch oilin engine.
• Walking speed too fast.
•Wom, bent or looseblade.
• Wheel heights uneven.
• Buildup ofgrass, leaves
and trash under mower.
• Worn, bent or loose blade.
• Bent engine crankshaft.
• Engine flywheel brake is on
when controlbar is released.
• Bent engine crankshaft.
• Blade adapter broken.
• Blade draggingin grass.
• Cutting height too low.
• Liftoo blade wom off.
• Catcher notventing air,
• Grass istoo highor wheel
heightis too low.
• Rear oflawn mower
housing or blade dragging
in grass.
• Grass catcher too full.
• Handle height position not
rightfor you.
CORRECTION
• Set to"Higher Cut"
position.
• Set to "Higher Cut"
position.
• Clean/replace air filter.
• Clean underside ofmower
housing.
• Check oillevel.
• Cut at slower walking
speed.
• Replace blade.'l]ghten
blade bolt.
• Set all wheels at same
height
• Clean underside of
mower housing.
• Replace blade. 1]ghten
blade bolt.
• Contact an authorized
service center.
• Depress controlbar to
upper handle before
pulling starter rope.
• Contact an authorized
service center.
• Replace blade adapter.
• Move lawn mower tocut
grass orto hard surface
to startengine.
• Raise cuttingheight.
• Replace blade.
• Clean grass catcher.
• Raise cutting height.
• Raise rear of lawn mower
housing one (1) setting
higher.
• Empty grass catcher.
• Adjust handle height to
suit.
18
Loading ...
Loading ...
Loading ...