Loading ...
Loading ...
Loading ...
_ WARNING: Alwayswear safelygogglesor safely
glasses with side shieldswhen operatingtools. Failure
to do so couldresultin objectsbeing thrownintoyour
eyes. resultinginpossibleserious injury.
_. WARNING: Do notallow familiaritywithyour mini
driverto make you careless. Remember thata careless
fractionofa second issufficienttoinflictsevere injury.
CHARGING BATTERY PACK
The battery pack inthis toolhas been shipped in a low
charge condition to prevent possible problems.Therefore,
you shouldcharge it 8 to 10 hours prior to use.
Note: Battery pack willnot reach full charge the firsttime it is
charged. Allowseveral cycles(drivingscrewsfollowedby
recharging)forbatterypack tobecome fullycharged.
TO CHARGE
• Lock switchby slidingthe lockbutton forward.
See Figure 2.
SWITCH
LOC
_k TO
LOCK
TO
YUNLOCK
Fig. 2
Remove batterypack from mini driver by depressing
tabs located on battery pack then pull on battery pack in
the direction of the arrow as shown in figure 3 to
remove.
TAB
•BA'n'ERY
PACK
TAB Fig. 3
• Charge battery pack onlywith the charger provided.
• Make sure power supply Is normal household
voltage, 120 volts, 60 Hz, AC only.
• Positionbatterypack sothat the key on batterypack
alignswith the key slotin charger. See Figure4.
,E,SLOT
UG.T (t" 1 "I .....
I _it /_-_k'it KEY BATI'ERY
I II / ,;cK
CHARGERs- _ TABS v Fig. 4
• Insertbattery pack incharger and press down until tabs
snap intoplace.
• Foldplugbladesoutthenconnectchargertopowersupply.
Note:Do not place charger in an area ofextreme heat
or cold.It willworkbest at normalroom temperature.
• The greenlightandredlightlocatedonfrontofchargerwill
turnon. The greenlightindicates thechargerisconnected
topowersupplyandwillremainon untildisoonnected.The
redlightindicatesbattery packischarging.
• Allowbatterypack tocharge 8 to 10 hours.
• Disconnect charger frompowersupply.
• Remove batterypack fromcharger by depressingtabs
on batterypack then pullto remove. Place batterypack
back in mini driver.
• Fold plug blades in and storecharger.
• After normal usage, a minimum of8 to 10 hours of
charging time isrequiredtobe fully charged.
COLLET
The coUetonyour mini driverhas been designed to accept
1/4 in. hex bits.
TO INSERT BIT
See Figure 5.
• Lockswitchby slidingthe lockbutton forward.
See Figure2.
• Remove frontcoverfrommini driver.See Figure5.
FRONT
_ COVER
BIT
C0LLET Fig. 5
• Insert bit intocolletas far as possible.
• When finishedusingyour minidriver, remove bit from
colletand placefrontcoverback onmini driver.
Loading ...
Loading ...
Loading ...