Bosch HBR33B550/45 Serie 8 Electric built-in oven

User Manual - Page 14

For HBR33B550/45.

PDF File Manual, 28 pages, Read Online | Download pdf file

HBR33B550/45 photo
Loading ...
Loading ...
Loading ...
14
Refitting the rails
1.First insert the rail into the rear socket, press it to the back
slightly (figure A),
2.and then hook it into the front socket (figure B).
The rails fit both the left and right sides. Ensure that, as shown
in figure B, levels 1 and 2 are below and levels 3, 4 and 5 are
above.
Folding down the grill element
You can fold down the grill element to clean the ceiling.
: Risk of burns!
The oven must be cold.
1.Hold the grill element and pull the handle forwards until it
clicks audibly in place (figure A).
2.Fold the grill element downwards (figure B).
3.After cleaning, fold the grill element back up and hold it.
4.Pull the handle downwards until it clicks audibly into place.
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels from the
oven door.
The oven door may open either to the left or to the right,
depending on the appliance model.
Removal and installation instructions for the door panels apply
to left and right-opening oven doors.
Removal
1.Open the oven door.
2.Unscrew the cover on top of the oven door. To do this, undo
the left and right screws (fig. A). Hold the panel with one
hand.
3.Pull the panel up and out (fig. B).
4.Unscrew the retaining carriers on the right and left and
remove them (fig. C). Lift out the panel upwards at an angle.
Clean the panels with glass cleaner and a soft cloth.
Do not use sharp or abrasive materials or a glass scraper. This
may damage the glass.
Fitting
When fitting, make sure that the lettering "right above" is at the
top right.
1.Insert the panel downwards at an angle and make sure that it
does not tip over (fig. A).
2.Stick the retaining carriers onto the right and left-hand sides
of the panel, aligning them so that they are over the screw
holes, and then screw in place (fig. B).
3.Insert the uppermost panel and hold in place. The smooth
surface must face outwards.
4.Put the cover back in place and screw it on.
5.Close the oven door.
Do not use the oven again until the panels have been
correctly fitted.
%
$
%
$
%
$
&
%
$
Loading ...
Loading ...
Loading ...