Loading ...
Loading ...
Loading ...
Tripp Lite by Eaton SmartOnline Series User Guide 614-21325—Rev 01 31
2. In the “Main Menu Screen” press the or button until the “IN / OUT SETTINGS” menu is displayed.
3. Press the
button. Use the or arrow buttons to display “HIGH EFFIC. MODE”.
4. Press the
button and change the setting to “ENABLED”.
5. The UPS transfers to High Efficiency mode after 5 minutes.
44..77 CCoonnffiigguurriinngg tthhee BBaatttteerryy SSeettttiinnggss
AAuuttoommaattiicc BBaatttteerryy TTeessttss
Automatic battery tests are once a month in constant charging mode.
The tests frequency can be modified.
During the test, the UPS transfers to Battery mode and discharges the batteries for 10 seconds under load.
Low battery warning
During discharge, the low battery alarm is activated if the remaining runtime goes below 3 minutes or less than
the setting capacity threshold (0 % by default). This threshold can be modified.
Restart battery level
This setting is used to define the battery restart level. The battery level must reach this threshold (0 % by
default) to enable UPS start.
See the 3.5 User Settings section to modify these settings.
44..88 RReettrriieevviinngg tthhee EEvveenntt LLoogg
To retrieve the Event log through the display:
1. From the “3.3 UPS Home Menu“ press the
button to enter into the “3.5 User Settings” screen .
2. In the “3.5 User Settings” press the
or button until the “Event Log” menu is displayed.
3. Press the
button. Use the or arrow buttons to display the events.
The log retains 50 events with the most recent event listed as the first event. Press the ESC button twice to
exit back to the “3.3 UPS Home Menu“ menu.
Configuring the Battery Settings
Loading ...
Loading ...
Loading ...