Loading ...
Loading ...
Loading ...
15
Whenever you hold
the tool, be careful
not to cover the air vents with your
hand. This blocks the air flow and
causes the motor to overheat.
Slide "On/Off" Switch
The tool is switched "ON" by the slide
switch 7 located on the topside of the
motor housing.
TO TURN THE TOOL "ON", slide the
switch button forward.
TO TURN THE TOOL "OFF", slide the
switch button backward.
Learn the Speeds
After the tool has been turned off:
- If you turn it back on within 5
minutes, the tool will turn on at its
last set speed setting.
- If turned on after 5 minutes, the tool
will turn on at its default speed
setting of 15,000 RPM.
Variable Speed Dial
Your tool is equipped with a variable
speed dial 8. The speed may be
adjusted during operation by rotating
the dial back or forth between any one
of the settings. One of the numbers on
the speed indicator 10 will light up
showing the current speed (Fig. 7).
You can refer to the charts on page 18
to determine the proper speed, based
on the materi al being worked and the
type of accessory being used. These
charts enable you to select both the
correct acces sory and the optimum
speed at a glance.
Increasing the pressure on the tool is
not the answer when it is not
performing as you think it should.
Perhaps you should be using a different
accessory, and perhaps an adjustment
in speed would solve the problem.
Leaning on the tool does not help.
Let speed do the work!
All Dremel Rotary Tool attachments are
compatible with your tool, but you may
experience reduced run times on the
battery when using certain attachments.
Learn the LED Behavior
If you turn off the tool with the battery
still inserted, the tool LEDs will behave
as follows:
- The Speed LED will remain
illuminated for 5 minutes to show the
last set speed setting.
- The Warning and Battery Gauge LEDs
will remain illuminated for 30
seconds.
To turn off all LEDs, remove the
battery pack after the tool has been
turned off.
Speed
Indicator
Number
Approximate Speed
Range, /min (RPM)
5 4,000-8,000
10 7,000–13,000
•15 12,000–15,000
20 19,000–23,000
25 22,000–25,000
30 26,000–30,000
• Wire Brush Setting.
Operating Instructions
Disconnect battery pack from tool before making any assembly,
adjustments or changing accessories. Such preventive safety measures
reduce the risk of starting the tool accidentally.
10
11
8
7
9
Fig. 7
Loading ...
Loading ...
Loading ...