Loading ...
Loading ...
Loading ...
ENGINE
Maintenance, repair, or replacement of
the emission control devices and sys-
tems, which are being done at the
customers expense, may be performed
by any non-road engine repair establish-
ment or individual. Warranty repairs must
be performed by an authorized engine
manufacturer's service outlet.
TO ADJUST THRO'R'LE CONTROL
CABLE
The throttle control has been preset at the
factory and adjustment should not be
necessary. Check adjustment as de-
scribed below before loosening cable. If
adjustment is necessary, proceed as
follows:
1. With engine not running, move throttle
control leverto fast position.
2. Check that speed controllever is
against stop screw. If it isnot, loosen
casing clamp screw and pull throttle
cable until lever Is against screw.
Tighten clamp screw securely.
Idle Fuel Idle Speed
Adjusting Needle i Screw
TO ADJUST CHOKE CONTROL
The choke control has been preset at the
factory and adjustment should not be
necessary, check adjustment as described
below before loosening cable. If adjust-
ment is necessary, proceed as follows:
1. With engine not running, move choke
control (located on dash panel) to full
choke position.
2. Remove air cleaner cover, filter and
cartridge plate to expose carburetor
choke (See =AIR FILTER" in the
Maintenance section of this manual).
3. Choke should be closed. If it Is not,
loosen casing clamp screw and move
choke cable until choke is completely
closed. Tighten casing clamp screw
securely.
4. Reassemble air cleaner.
Closed For
Choke
"hrottle
Control
Cable
Stop Screw
Screw
Choke
Control
29
Loading ...
Loading ...
Loading ...