Loading ...
Loading ...
Loading ...
en Installation instructions
20
4.
Insert the glass support in the opening and fold it
down as far as it will go.
5.
Align the glass panel at an angle of 90° to the ap-
pliance.
6.
Insert the glass panel in the opening on the appli-
ance and lock it into place.
90º
7.
Insert the glass support in the opening on the glass
panel and lock it into place.
8.
Remove the edge protection.
9.
Insert the grease filters.
10.
Connect the appliance to the power supply.
Piping
Note:If you are using an aluminium pipe, smooth the
connection area beforehand.
We recommend piping with an exhaust air pipe dia-
meter of 150mm.
If the diameter of the air extraction ducting is less than
150 mm, you need a separately available reduction fit-
ting.
Establishing the exhaust air connection (exhaust
pipe, 150mm diameter)
1.
Secure the exhaust pipe to the air pipe connector.
2.
Establish the connection to the exhaust air opening.
3.
Seal the joints.
Installing the flue duct
WARNING‒Risk of injury!
Components inside the appliance may have sharp
edges.
▶ Wear protective gloves.
WARNING‒Risk of electric shock!
Sharp-edged components inside the appliance may
damage the connecting cable.
▶ Do not kink or trap the connecting cable.
1.
To separate the flue ducts, remove the adhesive
tape or the flue duct from the protective packaging.
2.
Remove any protective foil from both flue ducts.
3.
Use the 2screws to screw the upper flue duct to
the sides of the retaining bracket.
4.
Note:To prevent scratches, lay soft towels over the
edges of the outer flue duct to protect the surface.
Place the lower flue duct on the appliance and pull
it slightly apart.
5.
Put the lower flue duct over the upper flue duct.
6.
Carefully remove the towels.
Loading ...
Loading ...
Loading ...