Operating Manual - Page 3

IMPORTANT: Do not store the keys inside your safe! Please keep secure in a separate place.

2. Next, remove the battery cover plate located on the inside of the door and install 4 AA batteries (provided).

Replace the battery cover.

SETTING UP YOUR PASSCODE FOR THE FIRST TIME

1. With the door open, locate the red button on the back of the door near the hinge. Press the red button, listen for a beep

and then enter your new user passcode. New user passcodes may be 3 to 6 digits long.

2. Immediately after entering your new code, press the “A” or “B” button on the keypad. Your new user code is now stored.

Note: This safe stores up to 2 passcodes simultaneously; a user code and a manager code. Entering a third code will erase

the rst passcode entered.

CHANGING YOUR PASSCODE

USING YOUR PERSONAL CODE TO OPEN THE SAFE

1. Imput your code, then press the “B” button, the green light will turn on.

2. Turn the knob clockwise within 5 seconds, the door is opened.

3. Each key being pressed is accompanied by a buzzer and a yellow ashing light. If the entered code is invalid the yellow light will

ash and teh buzzer will qu ickly beep and the user should enter the correct code again.

NOTE: If you forget your passcode, you can use the key to open the safe.

WRONG CODE PROTECTION

Entering an incorrect code 3 consecutive incorrect codes are entered, the keypad will lock for 20 seconds.

LOW VOLTAGE AND CHANGING THE BATTERIES

If both the red and green lights are on while the safe is open, this indicates the batteries are low and must be changed. To be sure