Loading ...
Loading ...
Loading ...
Preparing TheEngine
IMPORTANT: Refer to the engine operator's manual
included with the snow thrower for complete engine servicing
instructions.
WARNING! Never store the snow thrower with fuel
in the tank indoors or in poorly ventilated areas,
where fuel fumes may reach an open flame, spark or
pilot light as on a furnace, water heater, clothes
dryer or gas appliance.
PreparingTheSnowThrower
1. When storing the snow thrower in an unventilated or
metal storage shed, care should be taken to rustproof the
equipment. Using a light oil or silicone, coat the equipment,
especially any chains, springs, bearings and cables.
2. Remove all dirt from exterior of engine and equipment.
3. Follow lubrication recommendations in the Maintenance
section of this manual.
4. Store equipment in a clean, dry area.
Lubrication
1. Lubricate pivot points on the auger control and drive
control with a light engine oil once a season, see Fig. 6-2.
2. Lubricate the auger idler bracket with a light engine oil
once a season. See Fig.6-2.
f
AugerShaft
At least once a season, remove the shear pins from the auger
shaft. Spray lubricant inside the shaft and around the spacers and
the flange bearings found at either end of the shaft.
See Fig. 6-3.
I O_ro _o S
I
k
Figure 6-3
J
Wheels
At least once a season, remove both wheels. Clean and coat the
axles with a multipurpose automotive grease before reinstalling
wheels.
J
Figure 6-2
SECTION 6-- MAINTENANCE & ADJUSTMENTS
Loading ...
Loading ...
Loading ...