Loading ...
Loading ...
Loading ...
Page 10
OPERATION
BELT CLIP INSTALLATION (FIG. 2)
1. Align the rib of the belt clip with the hole
on the base of the impact driver.
2. Insert the screw and tighten the screw
securely with a Phillips head screwdriver
(not included). The belt clip can be
positioned on either side of the tool.
BELT CLIP REMOVAL (FIG. 2)
1. Use a Phillips head screwdriver (not
included) to loosen the screw that
attaches the belt clip to the impact
driver.
2. Remove the screw and the belt clip.
BIT STORAGE (FIG.3)
Your impact driver features a built-in bit
holder on the heel of the tool. After using
the bit, you can insert the bit into the bit
holder for convenient storage.
DIRECTION-OF-ROTATION
SELECTOR (FIG. 4)
The direction of bit rotation is reversible
and is controlled by the selector located
above the trigger switch. With the impact
driver held in normal operating position:
1. Position the direction-of-rotation
selector to the right of the tool for
reverse rotation to remove screws.
2. Position the direction-of-rotation
selector to the left of the tool for forward
rotation to drive the screws in.
3. Setting the direction-of-rotation selector
in the off (center-lock) position helps
reduce the possibility of accidental
starting the tool when it is not in use.
NOTICE: To prevent gear damage, always
allow the impact driver to come to a com-
plete stop before changing the direction of
rotation.
NOTICE: The impact driver will not run
unless the direction-of-rotation selector is
engaged fully to the left or right.
FIG. 2
Belt Clip
Screw
FIG. 3
BitBit Holder
FIG. 4
Loading ...
Loading ...
Loading ...