Loading ...
Loading ...
Loading ...
Howto Checkand Adjustthe MotionDriveBelt
If the motion drive belt is loose, the belt will slip when; (1)
going up a hill, (2) pulling a heavyload, or (3) the unit will
not move forward. Adjust the belt asfollows.
,_ WARNING:Beforeyou make an inspection,
adjustment,or repair to the unit, disconnectthe
wire tothe sparkplug. Removethewire from the
sparkplug to preventtheengine fromstarting by
accident.
1. Checkthe routing of the motion drive belt. Makesure
the belt is installed correctly and is inside all the belt
guides.
2. Disconnectthe clutchlinkfrom the idler arm (Figure
27).
3. Align the hole in the brake lever with the hole in the
frame. Hold the brake lever in placewith a 1/4 inch (6
mm} pinor bolt (Figure28).
4. Rotatethe clutchlink until the mounting hole in the
clutchlink is aligned with the hole in the idler arm as
shown in Figure27.
5. Connectthe clutchlink to the idler arm
(Figure 27).
6. Removethe 1/4 inch (6 mm) pin or bolt
(Figure 28).
Figure27: Aligning clutch link
A - Mounting holes
B - Idler arm
C- Clutchlink
D- Clutch rod
.
If the belt still slips after the belt has beenadjusted,
thenthe motion drive belt is worn or damagedand
must be replaced.See "Replacing The Motion
Drive Belt".
ยข'D
Figure28: Adjusting motion drive belt
A - 1/4"(6mm) Pin or bolt
B - Clutchlink
C - Idler arm
D - Idler spring
English
E - Motion drive belt
F - Beltguide
G- Brakelever
25
Loading ...
Loading ...
Loading ...