Loading ...
Loading ...
Loading ...
92 Instrument Panel and Multi-Function Display
Information
If the tir
e pressure falls below minimum pressure,
the message “Note min. pressure 26 psi
(1.8 bar)” appears and the new pressures are not
accepted. If this is the case, the required tire
pressures must be set again.
The new tire pressures have only been accepted
successfully when the message “New target
pressures” appears on the multi-function display.
When race circuit mode is activated, is
displayed permanently on the multi-function
display.
Returning to road mode
There are two options for returning to road mode.
Option 1
without switching off the ignition
If you change from race circuit mode to road
mode without first switching off the ignition, the
previous tire selection continues to be monitored.
f Use the pressure differences shown in the “Fill
info” display in the “TPMS” main menu or from
the corresponding tire pressure warning when
correcting the tire pressure.
Option 2
after switching off the ignition
When race circuit mode is activated, the
“Circuits” screen appears on the multi-function
display whenever the ignition is switched on,
together with the prompt (selection): “No”/“Yes”/
“New pressure”.
–“No”:
If you select “No” and then select the
“Tire type” menu, the required tire pressures
will be set back to road mode.
Tire Pressure Monitoring System will relearn the
wheels once you have returned to road mode.
During this process the required pressures for
cold tires (20 °C) are shown under “Fill info” in the
“TPMS” main menu.
f Please see the chapter “SYSTEM LEARNING”
on page 90.
f Once the Tire Pressure Monitoring System has
finished learning, check the tire pressure for all
wheels under “Fill info”.
f Correct the tire pressure to the required
pressure if necessary (differential pressure
value “0.0”).
–“Yes ”:
If you select “Ye s ”, this inserts the required tire
pressures that you set for driving on a race
circuit.
–“New pressure”:
If you select “New pressure”, you can set new
required tire pressures for driving on a race
circuit.
Information
If you make no selection before driving off, the
system automatically switches back to road mode
and the message “Tire change? Update
settings” appears.
f Update the multi-function display settings the
next time the vehicle is stationary.
1. Main menu “TPMS”
> “TPMS”
> “Circuits”
2. Select “Apply pressures”
and confirm.
1. Main menu “TPMS”
> “TPMS”
> “Circuits”
2. Select “No” and confirm.
Loading ...
Loading ...
Loading ...