Loading ...
Loading ...
Loading ...
12
EC ON ELECTROMAGNETIC COMPATIBILITY.
Functioning and use
Please note:
pull out the support outwards by placing
ngers in the slot (see gure on page 3). If the support isn’t
pulled out, the product will not stand up and fall down.
Always operate the heater in upright position only.
Any other position could create a hazardous situation.
1. Plug the appliance into the outlet.
2. Turn the thermostat dial to maximum.
3. Summer mode (fan only): turn the function selector to
the position (the indicator light will go on).
4. Low power operation: turn the function selector to posi-
tion 1 (the indicator light will go on).
5. High power operation: turn the function selector to po-
sition 2 (the indicator light will go on).
6. Switching o: turn the function selector to the “0” posi-
tion (the indicator light will go o).
Setting the thermostat
Position the thermostat on maximum.
When the room has reached the required temperature, turn
the thermostat dial slowly counterclockwise until you hear a
click and the fan goes o (the indicator light stays on). The
thermostat will then keep room temperature at the selected
level automatically.
Frost prevention mode
With the function selector in position 2 and the thermostat
dial in position
, the appliance maintains room tempera-
ture at about
5°C
(41°F)
, preventing freezing with minimal
energy consumption (the indicator light will stay on).
MAINTENANCE
- Always unplug from the outlet before cleaning.
- Clean the air intake and outlet grilles regularly.
- Do not use abrasive products or solvents to clean the
appliance.
SAFETY FUNCTIONS
- Safety device: the appliance is tted with a safety
device that switches it o in the event of accidental
overheating (e.g. obstruction of air intake and outlet
grilles, motor turning slowly or not at all).
To reset, unplug the appliance from the outlet for a few
minutes, remove the cause of overheating, then plug in
again. If the appliance doesn’t work please contact the
De’Longhi Customer Service.
- Tip-over safety device: certain models are tted
with a tip-over switch (D) which turns the appliance o
if it falls over. To restart the appliance, simply place it
upright again.
PROBLEM CAUSE SOLUTION
The appliance doesn’t work Be sure it is plugged in and that the
electrical outlet is working.
Check for any obstruction.
The function selector is in the ”0” po-
sition.
The thermostat may be set too low.
Plug into the outlet.
Remove the obstruction, unplug the
heater and let the appliance cool down.
If the appliance doesn't work please
contact the De longhi toll free number.
Turn the function selector to the position
or “1” or ”2”.
Turn the thermostat clockwise to a higher
setting until the heater restarts.
The tip-over switch has been activated
(certain models only).
Make sure the appliance is standing
upright on a at surface, if the problem
persists contact our toll free number to
assist you.
TROUBLESHOOTING