Loading ...
Loading ...
Removing Your Old Lavatory
— 3 —
STEP 1
Preparation
STEP 2
Determine Layout
Please inspect your working surface, making sure it is level and clean.
Determine the layout for the sink you desire. It is important to fully "dry" the position of the sink on the countertop. Aspects to note,
but are not limited to:
• Leaving enough clearance behind the faucet for operation of the handle.
•
Positioning the faucet so it does not interfere with the sink.
• Checking that the water flow from the faucet makes contact with the sink in the desired position.
STEP 3
Set Position
Mark and drill Φ 1 3/4 inch (4.4 cm) hole on countertop for drain placement.
STEP 4
Install the Sink
Make sure to use the intended style drain/pop-up. The vessel style
bowl does not have an overflow. Therefore, the drain/pop-up needs
to correspond appropriately.
Installation
•
•
•
•
•
Turn off the water supply. This is done by closing the two shut-off valves located under the lavatory. If there are no shut-off
valves leading to the lavatory, you must turn off the water at the main valve. This is usually located in the basement, garage
or near the foundation on the outside of the house. It may also be near the water meter.
Check to make sure the water is off, by turning on the faucet where you are working until the water stops flowing. If you have
shut off the main valve in a two-story house or greater you should open the kitchen faucet and another faucet on the same
level. Water will then drain from the entire line. This will help avoid spills.
Be sure to close the faucets before you turn on the main valve again.
Disconnect the drain pipes. Take off as many sections as possible between the lavatory and the wall or floor to facilitate
removal.
Place a basin under the work area to catch any water that may still be in the drain.
Installation must be done by a qualified licensed plumber.
Prior to installation please read the instructions thoroughly, confirm that all parts are included and visually inspect
the unit for any defects.
•
•
POP UP TOP
INTERNAL BRASS
PIECE (POP UP
MECHANISM)
RUBBER WASHER
DRAIN ASSEMBLY
WASHER
POP UP DRAIN TOP
BLACK PLASTIC
WASHER
DRAIN ASSEMBLY
INTERNAL BRASS
PIECE (POP UP
MECHANISM)
COUNTERTOP
BLACK PLASTIC
WASHER
DRAIN NUT
WHITE PLASTIC
WASHER
TAIL PIECE
COUNTERTOP
BLACK
PLASTIC
WASHER
DRAIN NUT
TAIL PIECE
WHITE
PLASTIC
WASHER
TO DRAIN
NOT
PROVIDED
Φ 1 3/4 inch (4.4 cm)
DO NOT OVERTIGHTEN THE DRAIN
POP UP
DRAIN
SINK
Loading ...
Loading ...
Loading ...