374UTMC User Manual

Loading ...

GARAGE DOOR OPENERS

Programming to a Garage Door Opener with a Program/LEARN Button

The Program/LEARN button is typically located on the back or side panel of the garage door opener or an external receiver. For

help locating your Program/LEARN button contact your garage door opener manufacturer.

If you have a LiftMaster or Chamberlain branded garage door opener with a yellow learn button, press and release the learn

button, then press and hold the button on the remote control you would like to use. If programming is not successful, proceed

through the steps below.

If you have a Genie

Intellicode

2 garage door opener go to the next page.

Theimagesthroughoutthismanualareforreferenceonlyandyourproductmaylookdifferent.

BottomButton

Startwithyourgaragedoorclosed.

Pressandholdbottombuttonontheremotecontroluntil

theblueLEDstayssolid(approximately15seconds)then

releasethebutton.

PressandreleasetheProgram/LEARNbuttononyour

garagedooropener.

Ontheremotecontrol,pressandreleasethebuttonthat

youwouldliketoprogramtwice.TheblueLEDwillblink

forupto60seconds.

5 6

Waitforthegaragedoortomove,thenpressandrelease

eitherofthebuttonsontheremote.

LED

Testtheremotecontrolbypressingthebuttonyou

programmedinstep4.Ifthegaragedooropenerdoesnot

activate,repeattheprogrammingsteps.

IMPORTANT: The remote will activate your garage door during

programming. Ensure garage door is clear of ALL obstructions.

LED

Loading ...

User Manual - Page 8