Loading ...
Loading ...
Loading ...
4
ASSEMBLY INSTRUCTIONS
BEFORE FIRST USE
Before using your Cuisinart
®
continuous feed
attachment for the first time, wash the work
bowl, stem adapter, and slinger disc
(see cleaning instructions at right).
1. Place the food processor housing base on a
dry, level countertop with the controls facing
you. Do not plug the unit in until it is fully
assembled.
2. Substitute the food processor work bowl for
the continuous feed attachment. Place the
continuous feed work bowl on top of food
processor base, with the work bowl handle
just to the right of center. Turn the work bowl
clockwise to lock it onto the housing base.
CONTINUOUS FEED
ATTACHMENT OPERATION
1. With the continuous feed work bowl locked
into place on the food processor housing
base, insert the stem adapter into the
continuous feed work bowl.
2. Hold slinger disc with rib facing up. Slide
slinger disc over the stem adapter until it is
firmly in place.
3. Carefully place slicing/shredding disc over
the stem adapter with the side being used
facing up.
4. Place the food processor work bowl cover,
with feed tube at the back of the work bowl,
on the work bowl by latching the back on first
and then pushing down on the front to lock
into place.
5. Plug the food processor base into an
electrical outlet.
6. Place a receptacle for processed food on
counter under chute. You can use bowls or
saucepans. Those with straight sides under
6 inches tall work best.
7. Put food in feed tube. Remember to cut one
end of food flat if you are slicing, and to insert
in feed tube flat side down. Insert pusher and
using light pressure, guide the food with one
hand, while using either high, low, or pulse
mode. Slinger disc will direct food through
chute into receptacle. Total amount of food
you can slice or shred is limited only by size
of receptacle under chute. You can replace
full receptacle with an empty one and
continue slicing or shredding.
CLEANING, STORAGE,
AND MAINTENANCE
Always unplug your Cuisinart
®
Food Processor
from the electrical outlet and remove the
Cuisinart
®
continuous feed attachment from the
food processor housing base before cleaning.
Keep the discs out of the reach of children.
• The work bowl, stem, and slinger disc are
dishwasher safe but on the top rack only. Due
to intense water heat, washing the work bowl,
stem, and slinger disc on the bottom rack may
cause damage over time. Insert the work bowl
upside down for drainage. Remember to
unload the dishwasher carefully when removing
sharp discs.
• To simplify cleaning, rinse the work bowl, stem
adapter, slinger disc, and slicing/shredding
discs immediately after use so food won’t dry
on them. If food lodges in the chute on the
work bowl, remove it by running water through
it, or use a bottle brush.
• If you wash the discs by hand, do it carefully.
When handling, use the plastic hubs. Avoid
leaving them in soapy water where they may
disappear from sight. If necessary, use a brush.
• Work bowl should not be placed in a
microwave oven.
Any other servicing should be performed by an
authorized service representative.
OPERATING AND SAFETY TIPS
Make sure the electrical outlet is rated at the
same voltage as that stated on the bottom of the
housing base.
• Always use the continuous feed attachment
with the Food Processor housing base on a
clean, sturdy, and dry surface.
• Don’t put hands inside the continuous
feed attachment work bowl or feed tube at
any time.
• Don’t remove continuous feed attachment
while unit is running.
• Handle and store metal discs carefully, utilizing
the storage hub provided with the food
processor. Their cutting edges are very sharp.
Loading ...
Loading ...
Loading ...