Loading ...
Loading ...
Loading ...
Care&Cleaning
Pullup withfinger
LeftGlide
[]
Push downwith finger
Figure 1
Figure 2
Removing and Replacing the Warming Drawer (Stainless Steel
models only)
To Remove Warming Drawer:
1. _ Turn power off before removing the warmer drawer.
2. Open the drawer to the fully opened position.
3. Locate glide lever on each side of drawer, pull up on the left glide lever and
push down on the right glide lever (See Fig. 1).
5. Pull the Warming Drawer away from the range.
To Replace Warming Drawer:
1. Pull the bearing glides to the front of the chassis glide (See Fig. 2).
2. Align the glide on each side of the drawer with the glide slots on the range.
3. Push the drawer intothe range until levers "click" (approximately 2"). Pull
the drawer open again to seat bearing glides intoposition. If you do not
hear the levers "click" or the bearing glides do not feel seated remove
the drawer and repeat steps I thru 3. This will minimize possible damage
to the bearing glides.
NOTE: The Warming Drawer will NOT operate while inthe "Self-Clean" and "Oven
Lockout" modes.
_'t"vA'/-'1:t_ll_[_'1Electrical Shock Hazard can occur and result
inserious injuryor death. Disconnect appliance from electric
power before cleaning and servicing the warmer drawer.
Wire
Holder
Figure 3
Operating and Replacing Oven Lights
Be sure the range is unplugged and all parts are COOL
before replacing the oven light(s). Wear a leather-faced glove for
protection against possible broken glass.
Operating the Oven Lights
Both of the interior oven lights automatically turn on when the oven
door is opened. Press _ to turn the lights ON and OFF when the
oven door isclosed. Each oven light is located at the rear wall of the
oven interior and is covered with a glass shield held by a wire holder
(See Figure 3). The Glass Shields must be in place whenever the oven
is in use.
To Replace the Oven Light:
1. Turn electrical power off at the main source and unplug the range.
2. Press Wire Holder to one side to release the glass shield.
3. Replace the old bulb with a new 40 watt appliance bulb.
4. Replace Glass Shield over bulb and snap Wire Holder intoplace.
5. Turn power back on again at the main source (or plug in the range).
6. The clock will then need to be reset. To reset, see Setting the
Clock in this Use & Care Manual.
31
Loading ...
Loading ...
Loading ...