Loading ...
Loading ...
Loading ...
INSTALLATION
BEFORE USING YOUR APPLIANCE
Remove all packing material before using your appliance.
IMPORTANT: Before connecting the unit to a power source, let it stand upright for approximately
24 hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
Clean the interior surface with lukewarm water and a soft cloth.
INSTALLATION OF YOUR APPLIANCE
This unit is designed for freestanding and built-in installation and indoor use only. Position the unit
in a dry and well-ventilated place. Avoid placing the cooler near any source of heat or moisture, or
in direct sunlight. Do NOT install the unit in a location with an ambient temperature that will fall
below °F.
For built-in installation, it is also important to keep space on each side and at the top of the
appliance. If you plan to install the unit into cabinetry, please leave ¼” space on each side and at
the top of the cooler as well as 1-2” at the back of the cooler to ensure proper air circulation to
cool the compressor and condenser. Also, be sure to not obstruct the front exhaust vent with any
objects as this may affect the unit from performing properly.
Place the appliance on a level surface strong enough to support it when it is fully loaded.
It is important for the appliance to be leveled in order to work properly. You may need to make
several adjustments to level it. To level the cooler, adjust the front leveling legs at the bottom of
the cooler.
For best performance it is recommended that you install the appliance in a location with an
ambient temperature between 41°-100°F. If the ambient temperature is above or below
recommended temperatures, the performance of the unit may be affected.
It is recommended that you do not install the appliance near an oven, radiator or other heating
source. Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Don’t install in a location where the temperature will fall below F. For best
performance, do not install the appliance behind a cabinet door or block the base grille.
Do not store or install the appliance outdoors, in a garage, basement, or in moist areas.
Plug the unit into an exclusive, properly installed-grounded wall outlet.
INSTALLATION OF THE METAL HANDLES
On the door interior, slightly pull back the
door gasket on the side you wish to install the
handle to reveal the two (2) designated holes
for handle installation.
NOTE: Door gasket must not be removed, detached or
altered as it may directly affect cooling performance.
Using a screwdriver (not included), install the handle tightly
as shown in the diagram above with the included screws,
lock washers and flat washers (2 each).
41°
41°
INSTALLING THE CHARCOAL FILTER
To install the charcoal filter, please follow the below instructions:
The back of the filter has a 3M glue tape which you can
affix to the shelf or the inside of the unit.
• Place the carbon filter on top of the shelf.
•
9
732 Sout h Race t rac k R oad , H end erson, N evada 89015
i n f o @ v i n o t e m p . c o m
Loading ...
Loading ...
Loading ...