Loading ...
Loading ...
Loading ...
4
Before You Start
= Do not turn the Whole Home Water Filtration System upside down, drop, or set on sharp protrusions.
= The Whole Home Water Filtration System has a maximum allowable inlet water pressure of 125 psi and a mini-
mum of 30 psi. If daytime pressure is over 80 psi, nighttime pressure may exceed the maximum. Use a pres-
sure reducing valve if necessary (Adding a pressure reducing valve may reduce the flow.). If your home is equip -
ped with a back flow preventer, an expansion tank must be installed in accordance with local codes and laws.
= The Whole Home Water Filtration System works on 24V DC electrical power, supplied by a direct plug-in power
supply (included). Be sure to use the included power supply and plug it into a nominal 120V, 60 Hz household
outlet that is in a dry location only, grounded and properly protected by an overcurrent device such as a circuit
breaker or fuse.
= Do not use the Whole Home Water Filtration System with water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after the system.
European Directive 2002/96/EC requires all electrical and electronic equipment to be disposed of accord-
ing to Waste Electrical and Electronic Equipment (WEEE) requirements. This directive or similar laws
are in place nationally and can vary from region to region. Please refer to your state and local laws for
proper disposal of this equipment.
Whole Home Water Filtration System Safety
Your safety and the safety of others are very important.
We have provided many safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING”
These words mean:
You can be killed or seriously injured if you don’t
immediately
follow instructions.
You can be killed or seriously injured if you don’t
follow instructions.
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell
you what can happen if the instructions are not followed.
In the state of Massachusetts: The Commonwealth of Massachusetts plumbing code 248-CMR shall
be adhered to. A licensed plumber shall be used for this installation.
Loading ...
Loading ...
Loading ...