Loading ...
Loading ...
Loading ...
10
Installation Instructions
STEP 5. INSTALL VALVE DRAIN HOSE
NOTE: See valve drain options on page 7.
1. Measure, cut to needed length and connect the 9.5
mm drain line (provided) to the Whole Home Water
Filtration System valve drain fitting (See Figure 10).
Use a hose clamp to hold the hose in place.
IMPORTANT: If codes require a rigid drain line see
“Valve Drain requirements" section.
2. Run the drain hose or copper tubing to the floor
drain. Secure drain hose. This will prevent the
drain line from “whipping'' during Clean Rinse
cycles. See “Air Gap Requirements" section.
STEP 6. TEST FOR LEAKS
1. Make sure the single bypass valve (or 3 valve
bypass, if installed) is in the bypass position, with
the handle pushed in (See Figure 10).
2. Fully open the main water supply valve.
3. Briefly open a faucet in the house to refill the plumb-
ing with water.
4. Slowly move the bypass valve(s) to the normal
operation position, pausing several times to allow
the unit to pressurize slowly (See Figure 10).
5. Check for leaks at all the plumbing connections you
made.
IMPORTANT: Start up procedure must be run prior to
using any filtered water. Follow the
instructions below and on Page 12.
STEP 7. TURN ON THE WHOLE HOME
WATER FILTRATION SYSTEM
During installation, the Whole Home Water Filtration
System wiring may be moved or jostled from place.
Check to be sure all leadwire connectors are secure
on the back of the electronic board and be sure all
wiring is away from the valve gear and motor area,
which rotates during Clean Rinse cycles.
1. Plug the Whole Home Water Filtration System’s
power supply into an electrical outlet that is not con-
trolled by a switch.
2. In the display, the words “PRESENT TIME” appear
and 12:00 PM begins to flash. Set the clock accord-
ing to the “Set Time of Day” section on Page 11.
3. Run the start up procedure, as detailed on Page 12.
SINGLE BYPASS VALVE
Pull handle
OUT for normal
operation
Push handle IN
for BYPASS
Drain Line
Connection
FIG. 10
Loading ...
Loading ...
Loading ...