Loading ...
Loading ...
Loading ...
6
• Respect the distances given in gure 2.
2
min. 11.8 in
min. 30 cm
min. 11.8 in
min. 30 cm
Proceed as follows:
• Drill a hole ø 5,25 inches (134 mm) in an outside wall or
through a wooden kickboard. Respect the dimensions and
height of the hole given in gure 3 and 4.
134
Ø 5,25 in
3
in the wooden
kickboard of a French
window or panel
in the wall:
you are
recommended to insulate the
section of wall using
suitable insulation
• Fit the wall ange B1 into the hole.
• Fit the hose B3 into the wall ange B1 as shown in g. 4.
• When the hose B3 is not connected, the drilled hole can be
closed with the ange cap B1.
4
max 39 in
max 100 cm
min 14 in
min 35 cm
• When installing the air conditioner, you should leave a door
slightly open little as 1/2“ (1 cm) to guarantee correct ven-
tilation and room pressure.
• Keep the air hoses as short and free of curves as possible to
avoid constrictions.
Note:
• As special tools are required for this type of
installation, we suggest you have the appliance in-
stalled by specialized personnel.
CONDITIONING WITHOUT INSTALLATION
You can also set-up in a double-hung window:
• Place the window bracket in the window sill, extend the
bracket fully within the window frame, x the bracket by
using the pin then lower the window onto the bracket.
(Should the window bracket be too large for the window,
the plastic can be cut with a saw by a qualied profes-
sional.)
• Fit the air exhaust hose B3 in the relevant housing located
on the rear side of the appliance. (g. 1).
• Connect the window outlet B5 to the other end of the ex-
haust hose.
• Insert the window outlet B5 of the exhaust hose into the
slot of the window bracket (g. 5).
5
Other set-up methods:
• Thanks to the locking pins, it’s possible to use the window
bracket also for sliding windows. Position the hole of the
bracket so to allow a correct installation of the exhaust hose
(see gure 6).
Loading ...
Loading ...
Loading ...