Loading ...
Loading ...
Loading ...
15 — English
Fig. 6
Fig. 7
LED INDICATOR
ON CHARGER
OPERATION
CHARGING THE MOWER
See Figures 6 - 7.
WARNING:
Only charge mower batteries indoors in a dry location. Do
not charge battery or expose mower to rain or damp loca-
tions. Water and liquids can come in contact with mower
components and the battery and damage connections
and electronic components, which can result in a short
circuit, increased risk of fire, and serious personal injury.
Mower batteries must be charged overnight before first
use. To verify mower batteries are fully charged, check the
battery level indicator.
For best results:
Do not charge in an area of extreme heat or cold.
Never charge a frozen battery.
Mount or place the charger in an area with adequate
ventilation, ideally with the charger in a horizontal position
with the cooling fins facing up.
To charge:
Make sure both the charger and mower connections are
clean and free of dirt or debris.
Insert charger plug into charging port on mower, making
sure it is properly connected.
Connect charger to power supply using normal household
current of 120 V, AC only, 60 Hz. The batteries should
automatically begin to charge.
NOTE: The charger is equipped with a plug featuring a
grounding pin and must be plugged into a matching stan-
dard three-prong outlet that has been properly installed
and grounded in accordance with all local codes and
ordinances. Do not use a two-prong outlet, adaptors, or
modify the plug provided. If it will not fit the outlet, have
the proper outlet installed by a qualified electrician.
When powered and connected to the mower, the LED
indicator on the charger will illuminate to indicate the
charger’s status. See the chart that follows to determine
the meaning of the LED’s display.
When you are ready to mow, disconnect the charger from
the power supply, then disconnect the charger from the
mower.
NOTICE:
Always turn power switch to OFF position and remove
key when charging mower and when mower is not in use.
LED INDICATOR BATTERY/CHARGER STATUS
Short green flash Batteries are less than 80% charged.
Long green flash Batteries are more than 80% charged.
Solid green Batteries are fully charged.
The following LED codes indicate an error condition of the charger. For details on how to clear the error, refer to the steps
in the Troubleshooting section at the end of this manual.
Red light turns on briefly then goes out Check for valid AC voltage to charger.
One red flash Charge Enable Fault
Two red flashes Battery Voltage Fault
Three red flashes Battery Charge Timeout: Charge Time Exceeded
Four red flashes Battery Fault: Charge Time Exceeded
Five red flashes Temperature Delay
Six red flashes Charger Fault
CHARGER
PLUG
CHARGING
PORT
Loading ...
Loading ...
Loading ...