Loading ...
Loading ...
Loading ...
ID number input success
After the last ID number is inputted, through,
the ignition switch ring and Honda SMART
Key Indicator will flash every 2 seconds until
the EM mode coupler is removed.
Be sure to remove the EM mode coupler and
return the blue dummy coupler. The ignition
switch is then unlocked. Reinstall the parts in
reverse order of removal and turn the ignition
switch to the ON position within 6 minutes. You
can start the engine.
To lock the ignition switch, turn the ignition switch
to the SEAT FUEL, OFF, or LOCK position, and
press and hold the ignition switch for 2 seconds.
The ignition switch also locks automatically when
the ignition switch has been in the SEAT FUEL,
OFF, or LOCK position for about 6 minutes after
the ID number is successfully inputted.
When the ignition switch is locked, the ignition
switch ring goes off.
To unlock the ignition switch again, repeat the
procedure for unlocking the ignition switch.
ID number input failure
After the last ID number is inputted, the
ignition switch ring and Honda SMART Key
Indicator will flash every second until the EM
mode coupler is removed, and the ignition
switch cannot be unlocked.
Pull out the EM mode coupler and reconnect
it to the EM mode connector. Follow the
procedure again. 2 P. 107
ID number input cancel
Pull out the EM mode coupler from the EM
mode connector.
Also, if you make a mistake while inputting the
ID number, remove the EM mode coupler from
the EM mode connector, connect it to the EM
mode connector again, and then re-input the
ID number from the beginning.
● Store the removed EM mode coupler in
the tool kit at all times.
20210315181706_31K0WA100_enu_BOOK Page 111 Monday, March 15 2021 18:22:26 JST
Unlock the Ignition Switch in an Emergency
Troubleshooting
108
Loading ...
Loading ...
Loading ...