Loading ...
Loading ...
Loading ...
9 — English
WARNING:
Keep the tool pointed away from yourself and others
when loading nails. Failure to do so could result in pos-
sible serious personal injury.
Slide the pusher all the way to the rear of the magazine.
Release the pusher and allow it to push the nails up to
the driving mechanism. The pusher will stop when it rests
against the end of the nail strip.
NOTE: Do not allow the pusher to snap back into place.
WARNING:
Use only the nails recommended for use with this tool.
The use of any other nails can result in tool malfunction,
leading to serious injuries.
WARNING:
Never load nails with the workpiece contact or trigger
activated. Doing so could result in possible serious per-
sonal injury.
WARNING:
Do not use nails with a shank smaller than 0.113 in. diam-
eter. Doing so may cause nails to exit the tool prematurely
through the guide track. Do not use hardened nails with
this tool. This could lead to excessive wear of the guide
body and allow nails to exit the back of the guide body,
leading to serious personal injury.
DEPTH OF DRIVE ADJUSTMENT
See Figure 6, page 14.
The depth-of-drive of the nail may be adjusted. It is advis-
able to test the depth on a scrap workpiece to determine
the required depth for the application.
To achieve the desired depth, use the depth-of-drive adjust-
ment on the tool.
Remove the battery pack and remove nails from the tool.
Turn the depth selector left or right to change the driving
depth.
Install the battery and reload the tool with nails.
Drive a test nail after each adjustment until the desired
depth is set.
NOTE: Set depth of drive at the shallowest depth that
will meet your needs.
DRIVING NAILS AT AN ANGLE
See Figure 7, page 14.
When driving nails at an angle, make sure that the tool is
pointed away from yourself and others.
When driving nails at an angle, make sure that the tool is
positioned correctly. Driving at an angle that is too steep may:
• cause the nail to miss the workpiece
• cause the nail to ricochet
• cause the workpiece to splinter, causing the nail to
come back toward the operator.
WARNING:
Never drive a nail at an angle by tilting the tool forward.
This could lead to the fastener missing the work surface
or bouncing off the work surface, leading to serious injury.
WARNING:
Remove the battery from the tool before removing nails or
clearing a jammed fastener. Failure to do so could result
in serious personal injury.
USING THE MODE SELECTOR SWITCH
See Figures 8 and 9, page 14.
WARNING:
Never wedge or hold back the workpiece contact mecha-
nism during operation of the tool. Doing so could result
in possible serious injury.
This tool is shipped from the factory with the mode selector
switch set in the Single Sequential Actuation mode. The mode
selector switch can also be set for Contact Actuation mode.
SINGLE SEQUENTIAL ACTUATION MODE
Single sequential actuation provides the most accurate nail
placement.
Remove battery pack from the tool.
Slide the selector to position (
).
WARNING:
The nailer will not function properly if the selec-
tor is not securely seated in either position ( ) or
( ). Always assure the selector is seated properly to
avoid an unexpected nail discharge and possible serious
personal injury.
Reinstall battery and activate the tool by pressing the
grip switch.
OPERATION
Loading ...
Loading ...
Loading ...