Loading ...
Loading ...
Loading ...
12 — English
NOTE: ILLUSTRATIONS START ON PAGE 13
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
PROBLEM POSSIBLE CAUSE SOLUTION
Workpiece contact does not depress
fully - tool does not operate
Low nails
Work-contacting element is jammed
Remove battery and replenish nails
Remove battery and clear jam
Tool operates properly, but nails do not
drive fully
Air pressure is too low
Depth of drive isn’t deep enough
Nail is too long for wood hardness
Trigger released too soon
Battery pairing is unsuitable
Refill air pressure tank
Adjust depth of drive
Use nail length that is appropriate for
wood
Hold trigger until fastener is driven
Use a 3Ah battery or higher
Tool operates properly, but nails are
driven too deep
Depth of drive is too deep Adjust depth of drive
Tool jams frequently Incorrect nails
Damaged nails
Loose magazine
Dirty magazine
Verify that nails are the correct size
Replace nails
Tighten screws
Clean magazine
Tool stops and LED flashes rapidly Battery is low or has no charge
Trigger released too early
Recharge battery
Remove battery and reinstall.
Tool has charged battery and LED is
slowly flashing or LED does not turn
off after approximately ten seconds of
non-use
Tool has malfunctioned Take tool to nearest authorized repair
center
TROUBLESHOOTING
LED LIGHT FUNCTIONS
Tool Status LED Light Scenario Action Required
Normal Solid Green Light (No Flashes) No Action Needed
Low Battery Solid Red Light (No Flashes)
Recharge or Replace Battery. If prob-
lem persists, contact an authorized
service center for repair.
Jam Mode Flashing Red Light
Clear Jam – See Clearing a Jammed
Fastener in Operations.
Loading ...
Loading ...
Loading ...