Loading ...
Loading ...
Loading ...
5
2. CONTROLS (CONT’D)
All units are equipped with an integrated control, located under the unit, on the recessed side
of electrical compartment. Plug the unit. Use the push button (1) to control the unit. The LED (2)
will then show on which mode the unit is in.
2.2 INTEGRATED CONTROL
VD0207
2
1
BOTTOM OF THE UNIT
Refer to table below.
LED COLOR RESULTS
AMBER UNIT IS ON LOW SPEED
GREEN UNIT IS ON HIGH SPEED
NO LIGHT UNIT IS OFF OR CONTROLLED BY A MAIN CONTROL
If a problem occurs during the unit operation, its integrated control LED (2) will blink. The color
of the blinking light depends on the type of error detected. Refer to Section 4 Troubleshooting
on last page for further details.
NOTE: When using main control, the integrated control must be turned off.
2.3 OPTIONAL MAIN AND AUXILIARY CONTROLS
For more convenience, these units can also be controlled using an optional main control.
Only one main control can be connected per unit.
NOTES: 1. The integrated control must be turned OFF to use an optional main control.
2. If an optional auxiliary control is used, its activation will override the main
control operation.
For more information about your unit controls, refer to the Main and auxiliary wall controls
user guide (included with your unit and also available at www.broan.com).
Loading ...
Loading ...
Loading ...