Loading ...
Loading ...
Loading ...
Rinnai 21 EHPT Heat Pump OIM - Issue 2
IMPORTANT
This appliance MUST NOT be connected via a switchable or a solar (photovoltaic - PV)
power supply without manufacturer consultation and authorisation.
The switching of the supplies will place the water heater into a re-start cycle which reduces
the available heating time and may result in a lack of hot water.
It is recommended this appliance is connected to either a 24 hour continuous tari or an
extended o-peak power supply (minimum 16 hours per day), noting that the minimum
required running time is governed by hot water demand and the climate zone.
If this appliance is replacing an electric water heater with a capacity of 250 litres (or greater),
then a connection to a 24 hour continuous tari supply is recommended.
Disconnect all power prior to installation and commissioning.
This appliance is designed for single phase 240 Volts, AC mains electrical operation.
Cord Management
Make sure that the power cord attaches to the power outlet at a point higher than it exits the appliance (1).
Alternatively loop the cord (2) so that any water is not directed to the the power socket.
1. Mount socket outlet higher than cord outlet
2. Loop applance cord
WIRING SCHEMATIC
INSTALLATION
Loading ...
Loading ...
Loading ...