Loading ...
Loading ...
Loading ...
sharkclean.com/AIRobotSEsharkclean.com/AIRobotSE
CLEANING SENSORS AND CHARGING CONTACTS
CLEANING SIDE BRUSHES
LIDAR MODULE
MAINTENANCE
!
Carefully unwind and remove any string or hair
wrapped around brushes.
Gently wipe brushes with a dry cloth. To reinstall,
snap the brushes over the pegs. Spin the brushes
manually to make sure they are installed correctly.
Periodically check the LIDAR navigation module
on top of the robot for hair and debris. Gently wipe
away any hair or debris from the module.
For a more thorough cleaning, place the robot on
a level surface and turn o the power. Use a cotton
swab to gently rotate the module clockwise five
times.
Do not insert cotton swab inside the openings in the
module.
CLEAN SENSORS AND CHARGING CONTACTS AS NEEDED. With a dry cloth, gently dust o the sensors
and contacts located on the bottom of the robot and on the base.
NOTE: Remove and replace any side brushes that are bent or damaged. To remove a brush, lift it o its peg.
IMPORTANT: The robot uses cli sensors to avoid stairs and other steep drops. Sensors may work less eectively when
they are dirty. For best results, clean sensors regularly.
CLEAN SIDE BRUSHES AS NEEDED.
BRUSHROLL
MAINTENANCE
The Brushroll actively removes hair wrap while your robot cleans. If some debris remains wrapped around
the brushroll, continue to run the robot to give the brushroll time to clean itself. If some hair wrap or debris
remains after continued cleaning, carefully remove it from the brushroll.
To access the brushroll, push up on the tabs on the
brushroll door, then lift o the door.
Lift out the brushroll and remove any debris.
Reinstall the brushroll, inserting the flat end first.
Close the brushroll door and press down until both
sides click into place.
NOTE: Replace brushroll every 6 to 12 months, or when visibly worn. See sharkaccessories.com for replacement parts.
Loading ...
Loading ...
Loading ...