Loading ...
Loading ...
Loading ...
28
ENGLISH
3. Allow the engine to cool. Remove the spark
plug and put 5 drops of any high-quality
motor oil or 2-cycle oil into the cylinder. Pull
the starter rope slowly to distribute the oil.
Reinstall the spark plug.
4. Thoroughly clean the unit and inspect it for
any loose or damaged parts. Repair or
replace damaged parts and tighten loose
screws, nuts or bolts.
TROUBLESHOOTING
PROBLEM SOLUTION
THE ENGINE WILL NOT START
The fuel tank is empty Fill the fuel tank with properly-mixed fuel
The primer bulb was not pressed enough Press the primer bulb 10 times
The engine is ooded
Move the choke lever to Position B, press the
throttle lockout, squeeze the throttle control and
pull the starter rope until the engine starts
The fuel is old (over 30 days) and/or improperly
mixed
Drain the fuel tank and add fresh, properly-
mixed fuel
The spark plug is fouled Replace the spark plug
THE ENGINE WILL NOT IDLE
The air lter is dirty Clean or replace the air lter
The fuel is old (over 30 days) and/or improperly
mixed
Drain the fuel tank and add fresh, properly-
mixed fuel
The idle speed is incorrect Adjust the idle speed
THE ENGINE WILL NOT ACCELERATE
The fuel is old (over 30 days) and/or improperly
mixed
Drain the fuel tank and add fresh, properly-
mixed fuel
The blades are jammed by debris Stop the unit and carefully remove the debris
The air lter is dirty Clean or replace the air lter
Preparing the Unit for Use after Long-term
Storage
1. Remove the spark plug. Tip the unit and
drain all of the oil from the cylinder into an
approved container. Reinstall the spark plug.
NOTE: Do not use fuel that has been stored for
more than 30 days. Dispose of old fuel
and oil according to federal, state and
local regulations.
CLEANING AND STORAGE - Continued
Loading ...
Loading ...
Loading ...