Loading ...
Loading ...
Loading ...
Your new tractor has been assembled at the factory with exception of those parts left
unassembled for shipping purposes. To ensure safe and proper operation of your
tractor all parts and hardware you assemble must be tightened securely. Use the
correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes you need
are listed below.
(1) 9/16"wrench (t) Pliers
(1) 1/2"wrench (1) UtiUty knife
(1) 3/4" socket with
drive ratchet
(1) Tire pressure gauge
When rightor left hand is mentioned in
this manual, it means, from your point of
view, when you are in the operating
position (seated behind the steering
wheel).
TO REMOVETRACTOR FROM
CARTON
UNPACK CARTON
1. Remove all accessible loose parts and
partscartons from carton.
2. Cut, from top to bottom, along lines on
all four comers of carton, and lay
panels flat.
3. Remove mower and packing materi-
als.
4. Check for any additional loose parts or
cartons and remove.
BEFORE REMOVINGTRACTOR
FROM SKID
ATFACH STEERING WHEEL
1. Remove hex bolt, look washer and
large flat washer from steering shaft.
2. Position front wheels of the tractor so
they are pointing straight forward.
3. Slide the steering sleeve over the
steering shaft•
4. Position steering wheel so cross bars
are horizontal (left to right) and slide
onto steering wheel adapter.
5. Secure steering wheel to steering
shaft with hex bolt, lock washer and
large flat washer previously removed.
Tighten securely.
6. Snap steering wheel insert into center
of steering wheel.
7. Remove protective materials from
tractor hood and grill.
IMPORTANT: Check for and remove any
staples in skid that may puncture tires
where tractor is to roll off skid.
_/_] _ /Steedng
_Wheel Insert
lr--.e.so.,
_Lock Washer
Steering LargeRat
Washer
Wheel
_JAdapte_
L
Steering Shaft-_ F --.:.." ;, -".-.-..
,,
v -- N
Sleeve /_,,'_7:_'L__, .., ., , ,,
HOWTO SET UPYOURTRACTOR
CHECK BA'n'ERY
1. Lift hoodto raised position.
NOTE: If this battery isput intoservice
after month end year indicated on label
(label located between terminals) charge
battery for minimum of one hour at 6-10
amps. (See "BATI'ERY" in Maintenance
section of this manual for charging
instructions).
Label
8
Loading ...
Loading ...
Loading ...