Loading ...
Loading ...
Loading ...
Message Cause Action
Next start hh:mm
The schedule setting prevents the product
from operating.
Change the schedule settings. Refer to
Schedule on page 22
.
The product has reached its maximum cut-
ting time for the day.
This behavior is normal and no action is re-
quired.
The clock or date in the product is not cor-
rect.
Set the time. Refer to
To set the time & date
on page 29
.
Today's mowing
completed
The product has reached its maximum cut-
ting time for the day.
This behavior is normal and no action is re-
quired. Refer to
Schedule on page 22
.
Connectivity problem
Potential problem on the connectivity circuit
board in the product.
Restart the product. If the problem stays
speak to your authorized service technician.
7.4 Indicator lamp in the charging station
The indicator lamp in the charging station must show a solid or flashing green light for a correct installation. If not,
follow the instructions in the troubleshooting guide below.
Speak to your Husqvarna customer service for more information.
Light
Cause Action
Green solid light Good signals Usual operation of the product.
Green flashing light The signals are good and
ECO mode
is ena-
bled.
Usual operation of the product. Refer to
ECO
mode on page 28
.
Blue flashing light The boundary wire is not connected to the
charging station.
Make sure that the boundary wire is correctly
installed in the charging station. Refer to
To
install the boundary wire on page 18
.
Damage in the boundary wire. Find out where the damage is. Replace the
damaged section with new boundary wire.
Red flashing light Interference in the antenna of the charging
station.
Speak to your Husqvarna customer service.
Red solid light Error in the circuit board or incorrect power
supply in the charging station. The error must
be corrected by an authorized service techni-
cian.
Speak to your Husqvarna customer service.
42 - Troubleshooting 1650 - 006 - 20.02.2023
Loading ...
Loading ...
Loading ...