Loading ...
Loading ...
Loading ...
Note: With the AIM function you can set work areas
and stay-out zones with a precision of approximately 1
m / 3.3 ft.
The data collection for the map starts automatically. The
product collects data while it operates and the map is
completed in 1-2 weeks. Remove temporary obstacles
on the lawn when the product operates and collects
data. If you change the installation of the wires or
charging station, you must do a new map. Read more
about in the Automower
®
Connect app.
4.1.4 Download firmware over the air FOTA
(Firmware over the air)
The product has a function that automatically downloads
new firmware. When a new firmware is available, a
notification shows in the app where you can select
to install the new firmware. In the factory setting this
function is enabled.
4.2 Product settings with keypad and
display
4.2.1 To get access to the menu in the
display of the product
1. Push the STOP button.
2. Use the number buttons and the OK button to
enter the PIN code.
3. Push the MENU button.
4.2.2 Menu structure
The main menu contains:
•
Schedule
•
Cutting height
•
Security
•
Messages
•
Weather timer
•
Installation
•
Settings
•
Accessories
Refer to
Menu structure overview - 1 on page 10
and
Menu structure overview - 2 on page 11
.
4.2.3 Schedule
Note:
The lawn should not be cut too often to obtain
the best result. If the product is allowed to operate too
much, the lawn may appear flattened. The product is
also subjected to unnecessary wear.
4.2.3.1 To set the schedule
1. Do steps 1–3 in
To get access to the menu in the
display of the product on page 22
.
2. Use the arrow buttons and the OK button to move
through the menu structure
Schedule > Overview
.
3. Use the arrow buttons and the OK button to select
the day.
4. Use the right arrow button to select the period.
5. Push the OK button.
6. Calculate the suitable operating hours. Refer to
Make an estimate of the necessary operating time
on page 22
.
7. Enter the time with the number buttons. The
product can cut the grass 1 or 2 periods each day.
8. If the product must not cut grass on a specified
day, unselect the box adjacent to the 2 time
periods.
4.2.3.2 Make an estimate of the necessary operating
time
If the work area is less than maximum product capacity,
the schedule must be set to decrease the wear on the
lawn and the product. The product has a maximum
cutting time each day. You can set the operating time of
the product in the schedule. The operating time includes
cutting, searching and charging. The operating time can
be different because of many reasons, for example the
layout of the work area, the grass growth and age of the
battery. When the product has operated to the maximum
cutting time in a day, the message
Today's mowing
complete
is shown in the display of the product.
The recommended operating times for some work area
examples are shown in the table below. If the result is
not satisfactory, increase the operating time.
Area, m
2
Recommended operating
time, h
500 10
1000 17
1500 24
4.2.3.3 To copy the schedule setting
1. Do steps 1–3 in
To get access to the menu in the
display of the product on page 22
.
22
- Product settings 1650 - 006 - 20.02.2023
Loading ...
Loading ...
Loading ...