Loading ...
Loading ...
Loading ...
Special InstallationInstructionsforAustralia andNew Zealand.
Installingthe WaterLine(cont.)
Connecting the Tubingto the Shutoff Valve
Attach the fitting with the male thread supplied
with the water supply kit to the shutoffvalve (or
pressure limiting valve, if fitted), and tighten.
NOTE: PTFE tape should be used for a water tight
seal when assembling all the above fittings.
Route the tubing through a hole drilled in the side
of the cupboard as close to the wall as possible.
Make sure there is sufficient length of tubing
[approximately 240 cm coiled into 3 turns of
approximately 25 cm] to allow the refrigerator
to move out from the wall after installation.
Insert and push tile end of tile tubing into tile
fitting as tar as possible.
_]th tile fl'ee end of tile tubing located in a
suitable container, turn tile main water sui)ply
On and flush out the tubing tmtil the water is clear.
Turn Off the shutott valve atier approximately 1 litre
of water has been flushed through tile tubing.
Connecting the Tubing to the Refrigerator
Before making the connection to the refrigerator, be
sure the power is turned OFFand the power cord is
disconnected from the Power Outlet.
If wmr refl'igerator does not include a water filteL
we recommend installing one in tile water line
near tile reti'igerator if yore" water sui)ply has sand
or particles that could clog the screen of the
refl'igerator's water wdve.
Remove tile refrigerator access cover.
Remove the plastic flexible cap fl'om the water wdve
(refl'igerator connection).
Attach tile fitting with tile female thread supplied
with the water supply kit to the water wflve and
tighten,
Insert and push tile end of tile tubing into tile
fitting as tar as possible.
Fasten tile tubing into tile clamp provided to hold
it in position. You may need to pry open tile clamp.
36
Loading ...
Loading ...