Loading ...
Loading ...
Loading ...
Installation Instructions
ROLLERS
The rollers have 3 purposes:
• Rolle_ a@lst so the door closes easily when opened
about hallway: [Raise the fl'ont about 5/8" (16 ram)
fl'om the flooi:]
• Rolle_ a(!iust so the refi_igerator is fi_mly positioned
on the floor and does not wobble.
• Rollet_ allow you to move the reti_igerator away fl'om
the wall fin" cleaning.
Final leveling a(!itlstments shotdd be made after the
refi_igerator has been installed.
To adjust the rollers on 25', 27' mad 29' models:
• Turn the roller
adjusting. ,_ screws
clockwise to raise
the reflJgerato_;
lower it. Use a 3/8"
hex socket or wrench,
OY _lIl ac!justable X
wrench. Roller adjusting screw
To adjust the rollers on 21' mad 23' models:
Remoxe the base grille by opening the (logic,
remo\Jng the screws at each end, and ptdling it
straight out.
O Turn the ti'ont roller
adjusting screws
clockwise to raise
the reflJgeratoi;
comlterclockwise to
lower it. Use a 3/8"
hex socket or wrench, _ .....
or an ac!justable
XV
wrench. Roller adjusting screws
These models also have rear a(!justable rolleI5 so you
can align the refi'igerator with your kitchen cabinets.
Use a long-handled 5/16" socket wrench to turn the
screws fi)r the rear rolle_-clockwise to raise the
refrigerat(n; comlterclockwise to lower it.
O Replace the base grille.
DOOR ALIGNMENT
_Mter leveling, make sure that the refi_igerator door is 1/16"
higher than the fl'eezer doo_:
To align the doors, at!just the reii_igerator doo_:
Using a 7/16" socket wrench, turn the door ac!justing
screw to the right to raise the dooi; to the left to lower
it. (A nylon phlg, imbedded in the threads of the pin,
prevents the pin ti'om turning tudess a wrench is used.)
O _Mter one or two turns of the wrench, open and close
the refl_igerator door and check the alignment at the
top _ff the (loo_.
Refrigeratordoor
needsto beraised.
ToremovethebasegdHe,
openthedoors,rernove
thescrewateachendof
thebasegrilleandthen
pullthegrillestraightout.
k [ 7/16" SocketWrench]
/ RaiseJ
26
Loading ...
Loading ...
Loading ...