Loading ...
Loading ...
Loading ...
REPLACINGBA'R'ERY
tc_rmCAUTIQN:.,Donotshortbaltery
inals oy allowing a wrencn or any
other object to contact both terminals at
the same time. Before connecting battery,
remove metal bracelets, wdstwatch
bands, rings, etc.
Positive terminal must be connected first
to prevent sparking from accidental
grounding.
1. Lift seat pan to raised position and
open battery box door.
2. Disconnect BLACK battery cable first
then RED battery cable and carefully
remove battery from tractor.
3. Install new battery with terminals in
same position as old battery.
4. First connect RED battery cable to
positive (+) terminal with hex bolt and
keps nut as shown. Tighten securely.
5. Connect BLACK grounding cable to
negative (-) terminal with remaining
hex bolt and keps nut. Tighten
securely.
6. Close battery box door.
Battery
Box
Keps Nut----_.
x Bolt
Positive (Red) Cable Negative (Block) Cable
TO REPLACE HEADLIGHT BULB
1. Raise hood.
2. Pull bulb holder out of the hole in the
backside of the grill.
3. Replace bulb in holder and push bulb
holder securely back into the hole in
the backside of the grill.
4. Close hood.
INTERLOCKS AND BELAYS
Loose or damaged widng may cause your
tractor to run poody, stop running, or
prevent it from starling.
• Check wiring. See electrical widng
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 20 amp automotive-type
plug-infuse. The fuse holder is located
behind the dash.
TO REMOVE HOOD AND GRILL AS-
SEMBLY
1. Raise hood.
2. Unsnap headlight wire connector.
3. Stand in front of tractor. Grasp hood at
sides, tilt toward engine and liftoff of
tractor.
4. To replace, reverse above procedure.
Hood
HeadlightWire
Connector
ENGINE
Maintenance, repair,or replacementof
emissioncontroldevices and systems,which
are beingdone at the custon'rersexpense,
may be performedby any non-roadengine
repair establishmentor individual.Warranty
repairsmustbe performed by an authorized
engine manufactursfs sen,ice outlet.
TO ADJUST THROTTLE CONTROL
CABLE
The throttlecontrolhas been presetat the
factoryand adjustmentshouldnot be
necassery.Check a_ustrnent as described
below before looseningcable. If adjustmentis
necessary, proceed as follows:
1. Withenginenot running,move throttle
controlleverfrom slowto choke position.
Slowlymove leverfrom choketo fast
position.
2. Check to see if hole in throttla laver and
holein spsed controlbracketare aligned.
3. If holesare not aligned, loosencable
clamp screwand _dignthe holesby
insertinga pencilor a 1/4"driUbitthrough
both holes.
4. Pullthrottle cable upto removeslackand
tightencable clamp screw. Remove
alignmentpencil or ddll bit.
27
Loading ...
Loading ...
Loading ...