Loading ...
Loading ...
Loading ...
BELTINSTALLATION-
4. Installnewbeltin reverseorder of
removal.
5, Make sure belt isin all pulleygrooves
and insideall beltguides.
6, Installmower inreverseorder of
removalinstructions.
TO ADJUST BRAKE
Yourtractorisequippedwithan adjustable
brakesystemwhichis mountedon the
sideofthetransaxle.
Iftractorrequiresmorethansix(6) feet
stoppingdistanceat highspeed inhighest
gear,then brakemustbe adjusted.
1. Depressclutch/brakepedaland
engageparkingbrake.
2. Measuredistancebetweenbrake
operatingarmandnut"A"onbrake rod.
3. Ifdistanceisotherthan 1-9/16', loosen
jam nutandturnnut=A"untildistance
becomes1-9/16". Retightenjam nut
against nut"A".
4. Roadtesttractorforproberstopping
distanceas statedabove. Readjustif
necessary.Ifstoppingdistanceisstill
greaterthansix(6) feet in highestgear,
further maintenanceisnecessary.
Contacta Searsor otherqualified
servicecenter.
With Perking Brake "Engaged"
Nut
- Operating
Arm
Do Not touchthis nut. If furtherbrakeadjust-
ment is necessarycontactyour nearest
authorizedservicecenter/department
TO REPLACE MOTION DRIVE BELT
Park the tractor on level surface. Engage
parking brake. For assistance, there is a
belt installation guide decal on bottom
side ofleft footrest.
1. Remove mower (See "TO REMOVE
MOWER" in this section of this
manual.)
2. Remove belt from stationary idler and
clutching idler.
3. Pull belt slack toward rear of tractor.
Carefully remove belt upwards from
transmission input pulley and over
cooling fan blades.
4. Pull belt toward front of tractor and
remove downward from around
engine pulley.
5. Install new belt by reversing above
procedure.
Engine
Pulley --------
ClutchingIdler_
StationanjIdler_
Transmission
Input Pulley,
C
TRANSAXLE MOTION CONTROL
LEVER NEUTRAL ADJUSTMENT
The motion control lever has been preset
at the factory and adjustment should not
be necessary.
1. Loosen adjustment bolt in front of the
right rear wheel, and lightly tighten.
2. Start engine and move motion control
lever untiltractor does not move
forward or backward.
3. Hold motion control lever in that
position and tum engine off.
4. While holding motion control lever in
place, loosen the adjustment bolt.
5. Move motion control lever to the
neutral (N) (lock gate) position,
6. Tighten adjustment bolt securely.
NOTE: If additional clearance is needed
to get to adjustment bolt, move mower
deck height to the lowest position.
After above adjustment is made, if the
tractor still creeps forward or backward
while motion control lever is in neutral
position, follow these steps:
1. Loosen the adjustment bolt.
25
Loading ...
Loading ...
Loading ...