Loading ...
Loading ...
Loading ...
3
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Extreme cold ambient temperatures may also cause the Beer
Dispenser not to perform properly. This unit is not designed for outside installation (ie garages,
porches, etc.)
• Avoid locating the Beer Dispenser in excessive humidity.
• Plug the Beer Dispenser into a dedicated, properly installed-grounded wall outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power cord. Any
questions concerning power and or grounding should be directed toward a certified electrician
or an authorized service center.
• After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before
placing any contents in the Beer Dispenser compartment.
¾ Electrical Connection
This Beer Dispenser should be properly grounded for your safety. The power cord of this Beer
Dispenser is equipped with a three-prong plug which mates with standard three prong wall outlets to
minimize the possibility of electrical shock.
Do not under any circumstances cut or remove the third ground prong from the power cord supplied.
Use of extension cords is not recommended.
This Beer Dispenser requires a standard 115/120-volt, 60Hz electrical outlet with three-prong ground
receptacle. The cord should be secured behind the Beer Dispenser and not left exposed or dangling
to prevent accidental injury.
Never unplug the Beer Dispenser by pulling the power cord. Always grip the plug firmly and pull
straight out from the receptacle.
WARNING
CO
2
GAS CAN BE DANGEROUS
WARNING: CO
2
cylinders contain high-pressure compressed gas which can be hazardous if not
handled properly. Make sure you READ and UNDERSTAND the following procedures for CO
2
cylinders BEFORE INSTALLATION.
1. ALWAYS connect the CO
2
cylinder to a regulator. Failure to do so could result in explosion
with possible injury when the cylinder valve is opened.
2. NEVER connect the CO
2
cylinder directly to the product container.
3. ALWAYS follow correct procedures when cylinders are changed.
4. ALWAYS secure the cylinder in an upright position.
5. NEVER drop or throw a CO
2
cylinder.
6. ALWAYS keep a CO
2
cylinder away from heat. Store extra cylinders in a cool place
(preferably 70°F). Securely fasten with a chain in an upright position when storing.
7. ALWAYS ventilate and leave the area immediately if CO
2
leakage has occurred.
8. ALWAYS check the D.O.T. test date on the cylinder neck before installation. If over five (5)
years, do not use, return cylinder to gas supplier.
9. NEVER connect a product container unless there are two (2) safety’s in the pressure system:
a. One at or on the CO
2
regulator
b. One at or on the product coupler or in the pressure gas line.
aWarninga
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by an authorized service center.
Loading ...
Loading ...
Loading ...