Loading ...
Loading ...
Loading ...
English
English27
STEP 5 Power on
Plug the power cord into an AC 120 V / 60 Hz / 15 AMP approved electrical outlet protected by a 15-amp fuse
or circuit breaker. Then, press
Power to turn on the washer.
STEP 6 Run a test cycle
Run a test cycle as follows to check if your washer is properly installed.
1. Load about 6 lb. of laundry into the tub.
2. Press Power to turn on your washer.
3. Turn the Cycle Selector to RINSE+SPIN.
4. Press and hold Start/Pause (Hold to Start) to start the test cycle.
5. The washer should not rock or vibrate excessively when water is supplied or when washing and spinning,
and should drain well during the spin cycle.
NOTE
If water leaks while water is being supplied or drained, check the water connections. See “Connect the
water hose” on page 21.
If the washer rocks and vibrates excessively, level your washer again. See “Level the washer” on page 24.
Untitled-2 27 2023-04-24  5:46:42
Loading ...
Loading ...
Loading ...