Loading ...
Loading ...
Loading ...
The shaver is a
washable appliance.
The head assembly
part may be cleaned
under water.
Trimmer
Cleaning and Care
NOTE: When cleaning your shaver, make sure the shaver is turned off and
disconnected from the power cord.
For optimal shaver performance, clean your shaver after each use.
The shaver is washable. The cutting head and hair pocket may be rinsed under
running tap water. Do not submerge the entire shaver handle under water for
cleaning.
Your shaver has a pop-up trimmer on the back for use
in trimming sideburns or edging beards or goatees.
1. To activate the pop-up trimmer turn the shaver on, then slide
the release button of the trimmer to pop the trimmer up. (D)
2. When trimming, pull the trimmer in the direction that keeps the
trimmer rigid. Pushing in the flexible direction of the trimmer
will cause it to close. (E)
3. To turn off the trimmer, flex the trimmer down against the
shaver body and snap it closed. (F)
Cleaning Instructions:
1. Turn the shaver off before cleaning.
2. Remove the cutting head by grasping the grips at the front and
back of the cutting head and pulling up and away from the
shaver body. (G)
3. Use the cleaning brush to remove loose clippings from the
inside of the cutting head and in the hair pocket. (H)
4. The cutting head and open hair pocket may be rinsed under
running tap water. (I)
5. Snap the cutting head back onto the shaver. (J) The cutting
head may be left off to air dry if desired.
J
G
H
I
When your rechargeable shaver reaches
the end of its useful life, the batteries
must be removed from the shaver and
recycled or disposed of properly in
accordance with your state and local
requirements. If this is not required by
law, you may elect to dispose of the
shaver with the batteries.
CAUTION! Do not put in fire or mutilate
your batteries when disposing as they
may burst and release toxic materi-
als. Do not short circuit as it may
cause burns. Dispose of properly in
accordance with your local and state
requirements.
Product Disposal
To Remove the Rechargeable Battery:
1. Run the shaver until the battery is fully
discharged.
2. Using a small tip screwdriver, unsnap
the two front side panels of the shaver’s
body at the left and right side of the on/off
switch.
3. Use a small screwdriver to remove the 4
exposed screw heads. Remove the front
panel.
4. Remove the eight exposed screws to
remove the back panel and open the inner
core of the shaver. This will expose the
battery.
5. Snip the battery wires with a scissors or
wire cutter, and pry the battery from the
circuit board.
6. Dispose of the battery appropriately.
Maintain your shaver’s peak
performance! Keep your shaver
performing like new!
Because your satisfaction is
important to us, we want to make
it simple for you to keep your new
shaver performing at its peak.
Did you know that for the best
possible shave, it is necessary to
replace the heads and cutters on
your shaver every 6 months?
Remington makes this easy!
Two easy ways to order!
1. Call! U.S. Residents call
800-392-6544.
2. Order Online at
RemingtonProducts.com
Warranty
Product Registration
By registering your new Remington
product you will receive these
important benefits:
Proof of ownership
Product protection
Product registration
Special offers
Register online at:
RemingtonProducts.com
Limited Two-Year Warranty
Spectrum Brands, Inc. warrants this product against any defects that are due to faulty
material or workmanship for a two-year period from the original date of consumer
purchase. This warranty does not include damage to the product resulting from
accident or misuse. If the product should become defective within the warranty
period, we will replace it free of charge. Return your product and sales receipt with
your name, address and day time phone number to: Remington Returns Center, 507
Stokely Dr., P.O. Box 1, Deforest, WI 53532
. For more information call 800-736-4648
in the U.S.
Warranty excludes: Foils and cutters
KEEP ORIGINAL SALES RECEIPT AS PROOF OF PURCHASE FOR WARRANTY
PURPOSES.
This warranty does not cover products damaged by the following:
Accident, misuse, abuse or alteration of the product
Servicing by unauthorized persons
Use with unauthorized accessories
Connecting it to incorrect current and voltage
Wrapping cord around appliance causing premature wear and breakage
Any other conditions beyond our control
No responsibility, obligation, or liability is assumed for the installation or mainte-
nance of this product.
SPECTRUM BRANDS, INC. SHALL NOT BE RESPONSIBLE FOR ANY
INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE
USE OF THIS PRODUCT. ALL IMPLIED WARRANTIES, INCLUDING BUT NOT
LIMITED TO IM PLIED WARRANTIES OF FITNESS AND MERCHANTABILITY, ARE
LIMITED IN DURATION TO TWO YEARS FROM DATE OF ORIGINAL PURCHASE.
This warranty gives you specific legal rights and you may also have other rights which vary
from state to state or province to province. Some states do not allow the exclusion or limitation
of incidental, special or consequential damages.
Spectrum Brands, Inc. Money-back Offer
If within 30 days after you have purchased your Remington
®
branded product, you are not
satisfied and would like a refund, return it with the sales slip indicating purchase price and
date of purchase to the retailer from whom it was purchased. Spectrum Brands, Inc. will
reimburse all retailers who accept the product within 30 days from the date of purchase.
If you have any questions concerning the money-back guarantee, please call 800-736-4648
in the U.S.
How to Order Shaver Accessories
Please refer to the shaver compari-
son and features chart near the
front of this manual that lists the
correct replacement part number
for your shaver.
It is very important to replace your
head and cutters when necessary to
ensure a close, comfortable shave
without irritation. We recommend they
be replaced every 6 months. Here are
some signs of head and cutter wear,
indicating that replacement
is needed:
Irritation: As the heads get
excessively worn you may
experience some skin irritation.
This would be especially noticeable
when you apply moisturizing lotion.
Pulling: When the cutters wear you
may feel a sense of pulling and a
loss of closeness when you shave.
This is an indication that it is time
to replace your heads and cutters.
Performance Guarantee
Remington Guarantees Satisfaction After 30 Days!
Remington 60-Day Money Back Guarantee*
If within 60 days after purchasing any Remington
®
branded product, you are not
completely satisfied and would like a refund, return it with the original dated
sales receipt directly to Remington and receive a full refund.**
For questions concerning the money-back guarantee, please call
800-736-4648 in the U.S.
*Applies to U.S. customers’ returns only.
**Terms and conditions apply.
Terms and Conditions
1. Refund will be in the form of a check issued in U.S. Dollars and will be provided
only if all Terms and Conditions are met.
2. The following items must be returned to Remington and postmarked no later
than 60 days after purchase of the Remington
®
branded product:
a. The Remington
®
product;
b. The original sales receipt indicating price and date purchased; and
c. The completed 60-day money back guarantee form located at
RemingtonProducts.com/60day.
3. In addition, Remington, in its discretion, must determine that the returned
product was used in accordance with the instruction booklet (included with the
product at the time of purchase).
4. Returns should be mailed prepaid (no collect returns accepted) to:
Remington 60-Day MBG
507 Stokely Drive, Box 1
DeForest, WI 53532
5. Refund does not include postage costs for the return of the product, but will
include applicable taxes paid by customer, if any.
6. No responsibility will be accepted for late, lost, stolen, misdirected or damaged
product.
7. Please allow 46 weeks to receive your refund by check.
Questions or comments: Call 800-736-4648 in the U.S.
or visit RemingtonProducts.com.
Dist. by: Spectrum Brands, Inc., Middleton, WI 53562
® Registered Trademark of Spectrum Brands, Inc.
© 2017 Spectrum Brands, Inc. 10/17 18165-01
Made in China.
T22-0005137-B
Contains a
listed adaptor
IMPORTANT SAFETY
INSTRUCTIONS - SAVE
THESE INSTRUCTIONS
DANGER - TO REDUCE THE
RISK OF FIRE OR ELECTRIC
SHOCK, CAREFULLY FOLLOW
THESE INSTRUCTIONS
For connection to a power supply not in the U.S.A., use an attachment plug adapter
of the proper configuration for the power outlet.
Power Adaptor
D
E
F
Loading ...