Loading ...
Loading ...
Loading ...
INSTALLATION- BUILT-
IN
NOTE: Due to the many different
you consult your local builder bef
Preparation
1. Select
a location that is not pro
from combustible materials su
2.
Mark the desired location on
place.
3.
Prepare a wall with a frame
least 1/4” (6mm) around the
compliance with local and na
P
rior to installing, test the applian
plugging the power supply cord i
The rough wall opening size of t
INSTALLATION
8
IN
fferent materials used to build walls, it is highly
er before you install t
his appliance on a wall.
not prone to moisture and is located at least 0.91
ials such as curtains, drapes, furniture, bedding,
on on the floor and store the appliance in a saf
framed opening to accommodate the size of
nd the edge of the appliance. Any new wirin
nd national codes and other applicable regulat
ppliance to make sure the appliance is fully op
plugging the power supply cord into a 240 Volt grou
nded outlet.
ze of the fireplace:
highly recommended that
wall.
st 0.91m or 3 feet away
ding, paper, etc.
a safe, dry and dus
t free
ze of your unit. Leave at
wiring must be done in
egulations.
ully operational by
Screw
Screw
1. Unscrew 1 screw on each left and right side and push the front glass panel upward a bit
to take it off. (The screws are only for protection during transportation.)
W(“)
SYM-SLIM-42/
42 1/2
D(“)
H(“)
4 3/8 15 5/8
(SM-X190042-1/EU2 /
WM-SLIM-45
SM-X190045-1/EU2)
Loading ...
Loading ...
Loading ...