Loading ...
Loading ...
Loading ...
38 Setting Oven Controls
Setting fresh clean (cont'd)
To cancel self-clean:
1. Press @.
CANCEL
2. If the self-clean cycle has heated the oven to a high enough
temperature, Hot (Figure 72) will appear in the display.
Allow enough time for the oven to cool and for the door
OPn message to display (Figure 73). When this message
turns OFF the oven door may be opened.
Setting delayed fresh clean
You may wish to set the oven to perform a self-clean at a later
time (up to 12 hours later). The end time key will determine
when the cleaning wilt stop.
The end time must be set far enough from the real time to allow
for the type of clean cycle you select, whether 2, 3, or 4 hours.
Remember to add 30 to 40 additional minutes of cooling time
before using the oven for cooking.
Setting for a heavy (4 hour) self clean cycle to end at 8:00
o'clock:
Fig. 72 Oven too hot for
door to unlock
Fig. 73 Door opens when
oven cools enough
Starting fresh clean after cancelling:
If a self clean cycle was cancelled using the cancel key before
the oven was finished cleaning, you may wish to set another
self-clean cycle.
If self clean was cancelled shortly after being started, and the
oven interior did not reach high self-clean temperatures, the
next clean cycle may be set as soon as the oven door unlocks
from the cancelled clean cycle.
If the oven reached high temperatures before the self-clean
cycle was cancelled, you may be required to wait up to 4 hours
before the control will allow another self-clean cycle to be
started.
Restarting afresh clean cycle after apower outage:
If the self-clean cycle was interrupted by a power failure, the
oven may not be thoroughly cleaned. Another self-clean cycle
may be needed. Once power is restored, the oven has cooled
and the door unlocks, set to clean for another cycle.
Setting repeated self-clean cycles
If attempting to set repeating self-clean cycles, the control may
display the message CLEAn then dELAy followed by the length
of time before the next self-clean may be set.
For example, if the message display reads "4:00" and the time
is 12:00 o'clock, the control will not allow a self-clean to be set
until after 4:00 o'clock.
1. Be sure the clock is set with the correct time of day. In
this example the time of day should be earlier than
4:00 o'clock. Remove all oven racks. Remove all items
from the cooktop. Be sure the oven door is completely
closed.
2. Press end time
3.
4.
(J3
-->l
end
time
Enter 8 0 0 using the numeric keypad 800
Press START 4>
START
5. Press fresh clean
fresh
dean
6. Press fresh clean again
2 |-=
fresh
dean
7. Press START 4>
START
Press CANCEL at any time to stop fresh clean
To avoid possible burns use caution opening the oven door after
the self-clean cycle is finished. The oven may still be VERY
HOT. Stand to the side of the oven when opening the door to
allow hot air to escape.
Loading ...
Loading ...
Loading ...