Loading ...
Loading ...
Loading ...
13
CONNECTING TO WATER SUPPLY
The machine has to be connected to water
supply by an adequately trained person.
Since ASKO washers have a built-in heating
element, you only need a cold water inlet. The
connection should be made by someone who is
sufficiently skilled. Use the hose supplied with
the washer. (The inlet hose is marked for correct
connection.) The water pressure must be in the
range 15–146 PSI. A valve should be fitted on
the water supply pipe. If a new supply pipe has
been installed for the washer, it should be flushed
thoroughly to remove any foreign particles that might
clog the filter in the fill valve.
The water intake hose has to be fastened fi rmly
enough for the hose to have a good seal.
After connecting the hose, the seal must be checked
for any leaks.
Only use the water supply hose supplied with the
appliance. Do not use any used or other hoses.
If the unit is installed on a second story, follow
local building codes. We recommend installing a
drip pan.
INSTALLING THE DRAIN HOSE
The machine is supplied with the outlet hose already
attached. The hose should be extended over a
suitable sink edge or drain pipe at a height of 24"
to 36" (610 mm to 914 mm) above the bottom of the
unit. (The lower height is preferable.) Make sure the
hose is not kinked.
24" to 36"
24" to 36"
24" to 36"
B
C
A
Loading ...
Loading ...
Loading ...