Loading ...
Loading ...
Loading ...
Performance Data Sheet
SmartWater Filtration System
GWF/ HWF Cartridge
Thissystemhasbeen testedaccording to NSF/ANS142/53for reduction of the substanceslisted below.
Theconcentrationof the indicated substancesin water entering the systemwas reduced to a concentration
less than or equal to thepermissible limit for water leaving the system,as specified in NSF/ANS142/53.*
(100%safety factors built in for unmetered usage)
Standard No. 42: Aesthetic Effects
Parameter
Chlorin(
T ,%()
Parti(ulale**
USEPA
MCL
]nfluent
Challenge Concentration
2.0 mgiL + 10 '_:
at ]easl 10,0(,_) [)m_lk ks/mE
Effluent
Average Maximum
0.02 ppm 0.05 ppm
3,978 7,800
Stmidard No. 53: Health Effects
Parameter Influent Effluent
% Rexluclion
Average Mhfimum
98.90% 97.37!'{
ChMlenge Concentration Average Maximmn Average
'Ihrbidity 11 + 1 NT[ *'::* 0.07 NTI 0.1 NT[ 99.71%
Cysts Minimum 50,0(_) L 26 55 99.97{_
Lead aI ptt 6.5 0.15 mgiI + 10% 1 ppb 1 ppb 99.37%
Lead al ptt 8.5 0.15 mgiI + 10% 1.8 ppb 4.3 ppb 98.8%
Lindane 0.1,q)2mgiL + 10{:{ 0.00005 ppm 0.00005 ppm 91.93%
Atmzine 0.1,q)9mgiL + 10{:{ 0.1,q)2ppm 0.003 ppm 76.19%
2,44) 0.210 mgiL + 101:{ 0.042 ppm 0.090 ppm 84.89%
A_bestos 10 r to 10*fibep_iL; 0.32 MFLiml 1.2 MFI.iml 99.951_
fibel'_ gwater fllan
10 micrometel'_ in length
Min. Reqtdred
Reduction
> 50%
> 85%
USEPA
MCL
1 NTI ***
{){).95%Reduction
15 ppb
15 ppb
(1.(1(1(12ppm
0.003 ppm
0.100 ppm
99%
% Reduction
Mitfimum
99.59!_
99.95%
99.37%
97.13%
91.93!_
64.28!_
67.63!_
99.82%
Mhl. Reqtfir_l
Reduction
0.5 NT[ 7
> 99.95!:_
0.010 mgiL
0.010 mgiL
0.01_)2 mg!L
0.(,q)3 mgiL
0.07 mgiI.
99%
Tested using a flow rate of O.5 gpm; pressure of 60 psig; pH of 7.5 _+O.5; temp. of 20 ° _+2.5°C
_ Measurement in Particles/ml. Particles used were 0.5-1 microns
_ NTU=Nephelometric Turbidity units
Operating Specifications
(_apacit'y: certified for up to 300 galhms (l 135 1); up to six months for models without a replacement filter indicator light;
up to one vear fi)r models with a replacelnelK filter indicator light
Pressure requirenlent: 40-120 psi (2.8-8.2 bar), non-shock
Temperature: 33-100°F (0.6-38°C)
Flow rate: 0.5 gpm (1.9 lpm)
General Installation/Operation/Maintenance Requirements
Flush new cartridge at full flow for .3 inilmtes to Imr°e_ out trapped air.
Replace cartridge when flow becolnes too slow.
Special Notices
h_stallation ii_sti uctions, parts and service availability, and standard warranty are ilwluded with the product when shipped.
This drinking water s_steln inust be inaintained according to inanufilcturer's instluctions, includii_g replacelnent of filter
ca rtridges.
Do not use with water that is microbiologically unsafe or of unknown tluali W without adequate disinfection before or
alter the svsteln, Svstelns certified for c_:st reductiola inav be used on disilffected water that inav contain filterable cysts,
The contanfilmlatS or other substances relnoved or reduced by this water treatmelat sx:steln are not necessarily in your
water.
_ Check tot compliance with the state and local laws and regtdations.
Note that while the testing was pertormed trader standard laboratoi T conditions, actual performance may w_rv.
Systems must be installed and operated in accordance with manufacturer's recommended procedures and gtfidelines.
System "I-(st_d and (2:rtifio:l by NSF Int_ rnational against ANSI/NSF Standard 4_ & :
fl)l _ Ih¢ re(hlction of:
StmMard No. 42: Aesthetic Effects
(ihemical Unit
'Ihste and Odor Reduction
Chlorine Reduction
Mechanical Fihration [nit
Partictflate Reduction, Class I
Standard No. 53: Health Effects
Chemical Re(hlction Unit
I.ead and Atrazine R(du(tion
Lindane and 2,4-I[) R( duclion
Medlanical Filtration [nit
Tmbiditv P.eduction
(_}'St ;all({ msb(_slos 1).( (lu(tion
Manufa(mred for: (;¢ neral Ele(tri( Company, Louisville, K%' 40225
36
Loading ...
Loading ...
Loading ...