Loading ...
Loading ...
Loading ...
3
4
ENGLISH
ENGLISH
GROUND CABLE
METAL FRAME
FUSE REPLACEMENT
WITH ATO TYPE ONLY
3 AMP
YOUR AMPLIFIER
SPEAKER 1
SPEAKER 2
+
-
+
-
+12V BATTERY YELLOW
REMOTE OUT
+12V BLUE
+12V RED
CHASSIS
GROUND
POINT
BATTERY
OPTIONAL DIRECT BATTERY WIRING CIRCUIT
BLACK
OPTIONAL
FUSE AND FUSE HOLDER
(NOT INCLUDED)
CHASSIS
GROUND
POINT
Recommended 16 ~ 18ga Primary Extension Wire
(not included)
CNO
Normally Open
ON/OFF ACC switch
Normally open
ACC switch
(not included)
YOUR
BATTERY
KILL SWITCH
RGB LED 2
RGB LED 1
YOUR RADIO
RGB LED 2
RGB LED 1
SYNC OUT
SYNC IN
RGB SYNC HUB
NOTE: ONLY USE SYNC IN/OUT WHEN CONNECTING
TWO OR MORE HUB SYSTEMS TOGETHER
INSERT
INSERT
RGB LED
EXTENSION WIRE
TO CONNECT MORE THAN
ONE SET OF MRGB65 TOGETHER,
PLUG THE SYNC OUT TO THE SYNC
INPUT OF THE NEXT SYSTEM
STRIPPED WIRE NEGATIVE
12FT
Splice BUTT connectors
3A
WIRE DIAGRAM
BEFORE INSTALLING THIS PRODUCT
When replacing the fuse, be sure to only use a fuse
of the rating specied on this product.
To avoid short-circuiting, cover any disconnected leads with insulating
tape. It is especially important to insulate any unused wires, which if left
uncovered may cause a short circuit. When connecting other devices to this
product, refer to the manual for the product to be connected. The black cable
is ground, make sure to connect the ground wire rst.
Ensure that the ground cable is properly connected to metal parts of the
vehicles body frame or direct to the battery if your vehicle does not have a
grounded chassis frame The ground cable of this units power amp and a
second powered system must be connected to the frame separately with
different screws. If the screw for the ground wire loosens or falls out, it
could result in re or malfunction.
To avoid potential shorts in the
electrical system, be sure to
disconnect the (–) battery cable before
installation. Use this unit with a 12-volt
battery and negative grounding only.
Failure to do so may result in a re or
malfunction.
TOOLS NEEDED:
- Wrench and/or Pliers
- #2 Phillips screwdriver
- Crimp tool
- Handsaw / Jig Saw
- Electrical tape
TECHNICAL SUPPORT
1-800-999-1236
www.bossaudio.com/support
CAUTION!! Do not ground or short the RGB wires
- Do not touch the speaker ex wire
- The RGB HUB controller should be installed in a non-metal and dry location
- Secure all wiring with wire ties
- Properly seal connections to ensure water tight connections
MRGB65-UM-DRAFT.indd 3-4 1/16/2015 9:31:38 AM
Loading ...
Loading ...