Loading ...
Loading ...
2
ENGLISH
THIS PACKAGE CONTAINS
2x- MRGB65 / MRGB65S Coax Speakers
(Depends on your model)
1x- RF Remote Controller
1x- RGB LED RF Sync Receiver HUB
2x- HUB Wire Extension Kit
2x- Speaker Wire & Mounting Hardware Kit
1x- User Manual / 1x- Warranty Card
USER MANUAL
QUICK START GUIDE
Thank you for purchasing this
MRGB65 6.5” Coax Speakers w/ RGB LED RF Controller
Please read through these instructions carefully so you will know
how to operate your model properly.
After you have nished reading these instructions, keep this
document in a safe place for future reference.
BEFORE YOU START
IMPORTANT SAFETY PRECAUTIONS
BE SURE TO OBSERVE THE FOLLOWING GUIDELINES:
- Do not turn up the volume so high that you can’t hear what’s around you.
- Use caution or temporarily discontinue use in potentially hazardous
situations.
■ Do not operate mobile video equipment while driving a motorized vehicle
■ Safe vehicle operation and safety consideration of others should always
be your highest priority.
■ Set your volume control at a low setting, then slowly increase the sound
until you can hear it comfortably without distortion, or ear discomfort.
■ In the event you should notice smoke, strange noises or odor from this
product, or any other abnormal signs, immediately turn off the power and
consult your dealer or the nearest authorized BOSS AUDIO Service Center.
Using this product in this condition may result in permanent damage to the
system.
INSTALLATION PRECAUTIONS
WARNING - Always consult with a professional installer
■ Do not attempt to install or service this product by yourself. Installation or
servicing of this product by persons without professional training and
experience in electronic equipment and motorized vehicle accessories may
be dangerous and could expose you to the risk of electric shock, injury or
other hazards
■ Refer any repairs to a qualied BOSS AUDIO SYSTEMS Service Center
■ The MRGB65 LED RGB SYNC HUB should be wired directly to a normally
open switch or relay.
■ When wiring directly to the vehicles battery, be sure to disconnect the
batteries negative terminal wire before starting any wiring procedures,if ex-
tending the main power wire, it is suggested that an optional fuse and fuse
holder (not included) with minimum rating of 10 Amperes be in-line with the
positive battery terminal
■ The ground cable length should not exceed 18-inches (See wiring diagram pg 4)
■ The MRGB65 has a weather resistant design, it should not be submerged
in or under water under any circumstances
■ Use only the installation parts provided with the MRGB65
FCC COMPLIANCE STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of this device.
MRGB65-UM-DRAFT.indd 2-2 1/16/2015 9:31:38 AM
Loading ...
Loading ...
Loading ...