Loading ...
Loading ...
Loading ...
English
EN-19
English
Troubleshooting
Problem Possible Causes and Solution
The oven display
stays OFF�
Turn off the power, and 1 minute later, turn on the power. If the
condition persists, contact a qualified technician or an authorized
service center.
Keys react even when
only their vicinity is
touched�
Clean the key surface and make sure the button surface is dry.
If the condition persists, contact a qualified technician or an
authorized service center.
Cooling fan continues
to run after oven is
turned off�
The cooling system comes into operation as soon as a cooking
function starts. It will continue to work for 15 minutes or until
the temperature of oven becomes below 160 °F (70 °C) after
cooking is finished.
Oven is not heating� (1) When using the reminder function, oven will turn on
automatically at preset time. Press
twice to cancel the
function. (2) Check the circuit breaker or fuse box to your house.
(3) Make sure there is proper electrical power to the oven. (4)
Make sure the oven temperature has been selected. (5) Make
sure the oven function has been selected.
Oven is not cooking
evenly�
(1) Verify food is not in the oven during preheating. (2) Verify
the cooking mode. (3) Refer to the operating instructions for tips
on the best rack position to use. (4) Check that the appropriate
temperature is set for the recipe.
Oven temperature is
too hot or too cold�
(1) Check that the appropriate temperature is set for the recipe.
(2) The heating elements are not working. If condition persists,
contact a qualified technician or an authorized service center.
Oven lamp is not
working properly�
Replace or reinsert the lamp bulb if loose or defective. Touching
the bulb with fingers may cause the bulb to burn out.
Clock and the
reminder function are
not working properly�
Make sure there is proper electrical power to the oven. See
Clock Setting (p. 9) and Reminder Function (p. 11).
Excessive moisture is
in the oven�
When cooking is finished, open the door slowly staying from the
oven as far as possible to prevent the body from being burned
by steam.
Enamel coating of
the oven cavity has
removed�
When oven racks are removed and replaced, always tilt
them upward and do not force them to prevent the enamel
from chipping. Even if a small area of the cavity enamel
has removed, it does not affect using. However, the soonest
replacement is recommended to prevent the metal under the
enamel coating from rusting.
The oven is not turned
on�
Check the circuit breaker and the fuse, and reset the circuit
breaker or replace the fuse if it is tripped or blown.
If the condition persists, contact a qualified technician or an
authorized service center.
The oven lamp is
dimming�
(1) This may be caused by the voltage instability when the
higher power level is used for cooking. It does not indicate
a problem with your oven. (2) Wipe and clean the covering glass
of the lamp to get the maximum brightness.
Loading ...
Loading ...
Loading ...