Loading ...
Loading ...
Loading ...
PROBLEM CHECK
Burners burn with a yellow or orange flame, in Inspect Spider/Insect Screens for possible obstructions. Clean Spider/Insect Screens. (See Section 'Annual
conjunction with the smell of gas. (Blockage of holes.) Maintenance")
The excess flow safety device, which is part of the
barbecue to cylinder connection, may have activated.
Symptoms:
Burners do not light. -or- Burners have asmall
flickering flame in the "HF position. -or-
Barbecue temperature onmy reaches 250 ° to 300 °
in the "HF position.
Burner does not might, or flame is mow in "HI"
position.
Experiencing flare-ups:
CAUTION: Do not line the bottom tray
with aluminum foil.
Is LP fuel low or empty?
Is fuel hose bent or kinked?
Does Burner 1 light with a match?
Are you preheating barbecue in the prescribed manner?
Are the cooking grates and Flavorize¢ _bars heavily
coated with burned-on grease?
Is the bottom tray "dirty" and not allowing grease to flow
into catch pan?
CURE
To reset the excess flow safety device turn all burner control
knobs and the cylinder valve off. Disconnect the regulator
from the cylinder. Turn burner control knobs to "HI'.' Wait at
least 1 minute. Turn burner control knobs to "OFF Reconnect
the regulator to the cylinder. Turn cylinder valve on slowly.
Refer to "Lighting Instructions'.'
Refill LP cylinder.
Straighten fuel hose.
If you can light Burner 1 with a match, then check the
Crossover _ ignition system.
All burners on HI for 10 to 15 minutes for preheating.
Clean thoroughly. (See Section "Cleaning")
Clean bottom tray.
Burner flame pattern is erratic. Fmame is low when Are burners clean? Clean burners. (See Section "Maintenance'.')
burner is on "Hi'; Flames do not run the whole
length of the burner tube.
inside of midappears to be "peeling." (Resembmes The lid is porcelain enamel or stainless steel, not paint. Clean thoroughly. (See Section "Cleaning'.')
paint peeling.) It cannot "peeE What you are seeing is baked on grease
that has turned to carbon and is flaking off.
THIS IS NOT A DEFECT.
Cabinet doors are not aligned. Check the adjustment pin on the bottom of each door. Loosen adjustment nut/s. Slide dooris until aligned. Tighten
nut.
if problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
site. Log onto www.weber.com ®.
PROBLEM
Side Burner does not light.
CHECK
Is gas supply off?
The excess flow safety device, which is part
of the barbecue to cylinder connection, may
have activated.
CURE
Turn supply on.
To reset the excess flow safety device turn all burner control knobs and the cylinder
valve off. Disconnect the regulator from the cylinder. Turn burner control knobs to
START/HI. Wait at least 1 minute. Turn burner control knobs to "OFF". Reconnect
the regulator to the cylinder. Turn cylinder valve on slowly. Refer to "Lighting
Instructions".
Flame is low in "HI" position. Is the fuel hose bent or kinked? Straighten hose.
Push button ignition does not work. Does burner light with a match? If match lights burner, check igniter (see Sideburner Maintenance).
if problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com ®.
Loading ...
Loading ...
Loading ...