Loading ...
Loading ...
Loading ...
7 — English
WARNING:
Make sure the latch on the bottom of the battery pack
snaps in place and the battery pack is fully seated and
secure in the battery port before beginning operation.
Failure to securely seat the battery pack could cause the
battery pack to fall out, resulting in serious personal injury.
NOTE: To avoid serious personal injury, always remove the
battery pack and keep hands clear of the lock-out button
when carrying or transporting the tool.
Depress the latches on each side of the battery pack.
Remove the battery pack.
For complete charging instructions, see the operator’s manu-
als for your battery pack and charger.
STARTING/STOPPING THE SPOT CLEANER
See Figure 5, page 10.
Starting and stopping the vacuum:
Depress the ON/OFF switch to turn on the vacuum.
Depress the ON/OFF switch to turn off the vacuum.
USING THE SPOT CLEANER
See Figures 6 - 9, pages 11.
NOTE:
Do not use the spot cleaner as a dry vacuum cleaner.
WARNING:
To prevent the product from falling, always keep the prod-
uct on flat surfaces while in use. Do not place product on
furniture. Positioning the unit on its side or tipped over
could allow liquid to enter the motor or battery. Battery
packs exposed to liquids can result in smoke/fire, serious
personal injury and/or property damage.
CAUTION:
Apply the cleaning solution sparingly to complete the
task. Excessive foaming may occur if too much cleaning
solution is present.
When using, monitor the amount of liquid waste present in
the recovery tank. When the tank reaches full capacity, the
float will engage and stop airflow through the hose. Turn the
unit OFF and empty the recovery tank.
NOTE: The cleaner will turn off within 10 seconds of the float
engaging if it is not manually turned off.
OPERATION
WARNING:
During use, make sure the unit does not get submerged
or doused in liquid, which could cause shock, unit failure,
or personal injury.
Preparing for use:
Furniture should be moved from the area being cleaned.
Place foil or wax paper under heavy furniture legs to
prevent bleeding from stained wood legs.
Pin up furniture skirts and draperies.
Move the spot cleaner to the area being cleaned.
To connect/remove the accessories:
NOTE: Use only accessories that are recommended for
this cleaner.
Remove the battery pack.
Align the raised tab on the end of the hose with the latch
on the accessory and press together until the latch snaps
into place.
To remove, depress the latch on accessory and pull the
accessory off of the hose nozzle.
To apply the cleaning solution:
Remove and unwrap the hose from the storage clips.
Insert the battery pack.
Press the ON/OFF button to start the spot cleaner.
Test spot cleaner on a small hidden area. Check for color
removal or bleed.
Hold the wide path nozzle at an angle and suction away
any excess liquid from the affected area.
NOTE: Do not use the spot cleaner to pick up chunky
messes.
Squeeze the spray trigger to apply cleaning solution.
NOTE: The cleaning solution is applied only while the spray
trigger is being pressed.
NOTE: For tough stains, pretreat the area with solution and
allow to soak for five minutes.
To clean with the crevice tool:
NOTE: The crevice tool is for tight spaces.
Attach the crevice tool as described above.
Use the bristles for scrubbing.
Turn the tool upside down to remove liquid.
NOTE: Do not press the spray trigger when removing liquid
or if the crevice tool is turned upside down.
Loading ...
Loading ...
Loading ...