Loading ...
Loading ...
Loading ...
English | 13
u If the plug is damaged, pay attention
to the following:
u Plugs and sockets situated near the
work site or outdoors should be to
class IP 55 of BS 5490 to provide
adequate protection against ingress
of water, etc. and cable entries re-
quire effective sealing. Rubber
shrouds should be provided over
cable glands. Drip-proof (class IP X2
of BS 5490) plugs and sockets to BS
4343 are suitable for use indoors
where the plug is away from the wa-
ter spray area where the appliance is
in use.
u Never touch the mains plug with wet
hands.
u Do not pull plug while operating the
device.
u Do not run over, crush or pull the
power supply cord or extension
cord, otherwise it may be damaged.
Protect the cable from heat, oil and
sharp edges.
u Do not use the unit, if the power sup-
ply cord or important parts, e.g.
high-pressure hose, power gun or
safety devices are damaged.
u Warning: Inadequate extension
cables can be dangerous.
u If an extension cord is used, the plug
and socket must be of watertight
construction. The extension cord
must have a cross section in accord-
ance with the operating instructions
and be protected against splashed
water. The connection must not be in
water.
u When replacing plugs on the power
supply cable or extension lead the
spray water guard and mechanical
stability must remain intact.
Water connection
u Comply with the regulations of your
water supply company.
u All connecting hoses must have
properly sealed joints.
u Make sure that the supply hose is at
least 12.7mm (1/2") in diameter
and is reinforced.
u The appliance should never be used
on the drinking water supply without
a back flow valve. Water which has
passed the back flow valve is re-
garded as undrinkable.
u The high-pressure hose must not be
damaged (danger of bursting). A
damaged high-pressure hose must
be replaced immediately. Only use
hoses and connections recommen-
ded by the manufacturer.
u High-pressure hoses, fittings and
couplings are important for the
safety of the appliance. Use only
hoses, fittings and couplings recom-
mended by the manufacturer.
u Only clean or filtered water should
be used for intake.
Application
u Before use, check that the machine
and operating equipment are in per-
Bosch Power ToolsF 016 L81 693 | (30.04.2019)
Loading ...
Loading ...
Loading ...